Through Feb 1st---see post #12

TPIS ZZX late-model step nose cam USED. Lift is .558 on intake and exhaust. 111 degrees lobe separation. 240 degree duration at .050 lift.
http://www.thirdgen.org/techboard/en...ro-roller.html
$175 plus shipping

above listed in same ad as roller lifters.

Vortec TPI intake NEW
http://www.thirdgen.org/techboard/en...ntake-new.html
$425 plus shipping


United States Postal Money Orders ONLY. No checks, no offbeat money orders, no PAYPAL. United States Postal Money Orders ONLY.

jmssrf@scrtc.com

jms

 

ttt

 

fixed a dead link.

The ZZX cam was designed for a serious LT1 or L98. Pretty stout cam for a hydraulic roller.

 

Rev KIT SOLD

 

lots of good stuff here.

jms

 

I've got a lot of good stuff for sale but I honestly thought the ZZX cam would be gone first. It works great with an LT1 and/or a modified TPI system.

jms

 

ttt

 

ttt for some good parts.

 

Center-bolt Corvette valve covers have been sold and shipped.
(Perimeter-bolt covers still for sale).

Brackets also sold and will be shipped tomorrow.

Thanks,
jms

 

The cam would make very good power for someone.

jms

 

ttt for good parts

jms

 

Until February 1st---ONLY, I will take $150 shipped (US 48 states only) for the used ZZX Cam.

Until February 1st---ONLY, I will take $250 shipped (US 48 states only) for the new Crane hydraulic roller lifters.

Until February 1st---ONLY, I will take $350 shipped (US 48 states only) for the new vortec TPI intake.

Until February 1st---ONLY, I will take $40 shipped (US 48 states only) for the used TPI distributor, new cap and new rotor.

United States Post Office money order ONLY.

jms

 

ttt

 

Folks, it has come to my attention some of my replies have not been getting back to some of you.

If you have sent me a message, either by email or PM (private message) and I have not returned an answer, please let me know.

Apparently something is not working correctly on my end. I am certainly no computer expert, so, please, if you sent a message, and are awaiting a reply, please, please, contact me again at my regular email:

jmssrf@scrtc.com

I always try to reply to messages, so forgive me if you should have got one by now.

Thanks,
James Spear (jms)

 

Cam is still for sale.

I have had several contacts about it but no definate sale (where someone says: I will take it and am sending money order).

Vortec TPI intake still for sale.

Distributor still for sale.

Lifter are Sale Pending.

Thanks,
James Spear