Wilwood 6 piston fronts and 4 piston rears calipers
#1
Wilwood 6 piston fronts and 4 piston rears calipers
This is a 1993-1997 Camaro/Firebird 6 piston fronts and 4 piston rears calipers. Two piece front and one piece rear rotors. Rears have e-brake set up.Was told setup had 10,000 miles, but rotors show wear, though buying new rotors for the hats is fairly cheap, I was going to run as is, Comes with stainless lines, spindles and all hareware(no pads) the part numbers are 140-6743 and 140-7148. I bought to try and put on my 1976 Trans AM but figured it was to big a pain in the bottom. Kit runs about 2300 or so.. Im letting it got for $800 plus shipping. I have a ton of picture. I know you can make this work on a LS1 just need to modify spindles. I have paypal if you want to pay that way. Shipping will be around a 100 bucks.. Its heavy. I will charge actual shipping.. Its on lS1tech with my trader rating if your interested,
Note: spindles in pics are not included..
Note: spindles in pics are not included..
Last edited by qnitro; 11-19-2010 at 01:34 PM.
#3
Ws6
Would you be interested in a partial swap for a 79" WS6 rear rotor set up & cash? Original parts in working condition. This would be an easy bolt on your 10/12 bolt rear end. The parts have about 5000 miles since I cleaned them up and installed them on my 78'. Parking brake works fine. They are not show quality but I think it will be hard to find original equipment that is.
I have a ford 9" ready to go in my 78' with ford drums on it. I'll probably go with a set up from an expidition after the current upgrades are done.
This would include everything from the backing plates to the rotors / pads.
I have a ford 9" ready to go in my 78' with ford drums on it. I'll probably go with a set up from an expidition after the current upgrades are done.
This would include everything from the backing plates to the rotors / pads.
#5
Thread
Thread Starter
Forum
Replies
Last Post
Hurin
Suspension, Chassis, and Brakes
4
12-13-2014 07:38 PM