dreamer1q

Here is my plethora of stuff that I need to move out of the garage. Prices are not shipped.

The only trade I am looking for is a dual exhaust setup for a LT1 with Hookers Long Tubes on a Camaro

Set of 2000 Firebird power door switches. Passenger side missing one button, driver complete. Gray 65.00 http://www.michiganspeed.com/dreamer...rebirdgray.jpg

Driver side 2000 Firebird power door switch. Black 45.00 http://www.michiganspeed.com/dreamer...ebirdblack.jpg

Long tube headers for 4.8, 5.3, and 6.0 liter motors. These were Harlans old headers from his truck. Have EGR fitting on them, with O2 bungs. Need to be recoated. But other then that in great shape. Want what I paid, 375.00 http://www.michiganspeed.com/dreamer...ng/headers.jpg
http://www.michiganspeed.com/dreamer...g/headers2.jpg

Set of 2001 Camaro power door switches. Passenger side missing one button. Gray 65.00 http://www.michiganspeed.com/dreamer...camarogray.jpg

LT1 intake already punched out to 58mm throttle body. No sensors, just bare intake. 95.00 www.michiganspeed.com/dreamer1q/selling/lt1.jpg http://www.michiganspeed.com/dreamer...ing/intake.jpg

LT1 1994 Camaro RS Ground Effects package. Comes with 2 front valances and both side skirts. Both front valances are scuffed up. One from driving, one from the body shop prepping it for paint. A couple of eyes are cracked, but nothing a plastic welder or washer wouldnt fix. Passenger side skirt has a small crack as well. Once again, nothing that the body shop who paints them couldnt fix. My body shop was going to do it, till I changed my mind and took them off. 375.00
www.michiganspeed.com/dreamer1q/selling/val.jpg
www.michiganspeed.com/dreamer1q/selling/val2.jpg
www.michiganspeed.com/dreamer1q/selling/val3.jpg
www.michiganspeed.com/dreamer1q/selling/val4.jpg
http://www.michiganspeed.com/dreamer...ling/skirt.jpg
http://www.michiganspeed.com/dreamer...ing/skirt2.jpg
http://www.michiganspeed.com/dreamer...ing/skirt3.jpg
http://www.michiganspeed.com/dreamer...ing/skirt4.jpg
http://www.michiganspeed.com/dreamer...ling/crack.jpg

SLP Quad out rear exhaust for Camaro with both side fasicas and a Dynomax muffler. System sounds good, not to loud, and wakes up under throttle. 300.00
http://www.dreamer1q.michiganspeed.c...3/DSC01939.JPG

Oil pressure gauge 2 5/8 mechanical. Autometer Auto Gauge. Black face with chrome ring. New in the box, never installed. 30.00
www.michiganspeed.com/dreamer1q/selling/oil.jpg

Water temp gauge 2 5/8 mechanical. Autometer Auto Gauge. Black face with chrome ring. New in box, never installed. 30.00
http://www.michiganspeed.com/dreamer...ling/water.jpg

Black mounting plate for 2, 2 5/8 gauges. Brand new, but out of package. Never used. 15.00
http://www.michiganspeed.com/dreamer...gaugepanel.jpg

MSD 3 step box. No pills, worked great. 35.00
http://www.michiganspeed.com/dreamer...ling/3step.jpg

Mass Air Flow Tuner for LT1. Plugs inline of the MAF and allows you to fool the computer to add or pull fuel and timing. 125.00
www.michiganspeed.com/dreamer1q/selling/maf.jpg

5 inch monster tach, Autometer. Lighted with adjustable shift light controls. Shift light not included. 75.00
www.michiganspeed.com/dreamer1q/selling/tach.jph

O2 sims for LS1 car. Square plug, set of two. 50.00
www.michiganspeed.com/dreamer1q/selling/sims.jpg

4 low air sensors from a 2002 Corvette. Complete set, worked fine when removed. 150.00
http://www.michiganspeed.com/dreamer...ing/lowair.jpg

Throttle body from a 5.3 liter truck motor. Works fine, has a few sensors still on it. 65.00
www.michiganspeed.com/dreamer1q/selling/tb.jpg

Fuel rails from 5.3 truck with stock injectors. Good shape, 40k on injectors. 75.00
http://www.michiganspeed.com/dreamer...ling/rails.jpg

LT1 T56 slave and master clutch cylinder setup. Brand new, used only to test setup. Less then 10 miles on it. 100.00
http://www.michiganspeed.com/dreamer.../withslave.jpg

LT1 T56 Master cylinder and resouviour for clutch. Slave unit on the transmission is not there. Everything else including braided line is still there. 50.00
http://www.michiganspeed.com/dreamer...ng/noslave.jpg

Set of 4 TAKE OFF 2500 HD shocks. These have less then 20 miles on them. They are compressed and ready to go on your truck. Basically brand new. 65.00

Set of 4 chrome 8 lug Silverado stock wheels. No center caps. 16 inch in size. Nice wheels, great for winter tires or dress up for painted silver wheels. 125.00 for set.
http://www.michiganspeed.com/dreamer...ling/wheel.jpg

Also selling my 2000 3 door NBS 2500. 91k on the 6.0 with 4L80E, dual exhaust, pewter in color with black flares. No moldings or decals on body. LT interior, ebony dual power heated seats, AC, Billet grille, rear slider, projection headlights, fog lights always on, and high beams with low beams mods done. Has 305 tires on the polished factory rims. Comes with soft tonneau, and paint matched leer cap. Factory stereo, unless someone wants to pay extra for the Pioneer MP3 player with 10 inch Cerwin Vega and Kenwood amp. Steel skid plates go with it, just not on truck yet. All recalls taken care of. Great truck, I really love the hell out of it, its clean and rides and tows great. But I need a four door, so its time for a Avalanche. 15500.00 without stereo, 16000.00 with stereo.

http://www.michiganspeed.com/dreamer...truckright.jpg
http://www.michiganspeed.com/dreamer.../truckleft.jpg

I have a Camaro bezel for around the radio and HVAC controls. 40.00
http://www.michiganspeed.com/dreamer...amarobezel.jpg

2 Driver side door switches for NBS Silverado. 45.00 each
http://www.michiganspeed.com/dreamer...doswitches.jpg

Set of Power door switches from a 2004 Denali. Great shape. 85.00
http://www.michiganspeed.com/dreamer...liswitches.jpg

Comp cams Vacumn Canister for the nasty cam we all wish we had. 30 bucks
http://www.michiganspeed.com/dreamer...ing/vancan.jpg

LT1 Alternator underdrive pulley. Anadoized red. Slight scratch, but all nuts are there. 20 bucks
http://www.michiganspeed.com/dreamer...ling/pully.jpg

Set of hardned push rods, 7 inch Engine Pros. Used for less then 100 miles. 65.00
http://www.michiganspeed.com/dreamer...ng/pushrod.jpg
www.michiganspeed.com/dreamer1q/selling/pushrod 2.jpg

LT1 MSD Blaster coil. Used one season. 35.00
www.michiganspeed.com/dreamer1q/selling/coil.jpg

Angle rings for small sized gauges. 5 of them. 15 bucks shipped
http://www.michiganspeed.com/dreamer...ling/rings.jpg

Kelsea electric brake controller. 20.00
http://www.michiganspeed.com/dreamer...ling/brake.jpg

1999 Explorer console cover, Tan. Not ripped. 25.00
www.michiganspeed.com/dreamer1q/selling/lid.jpg

NBS Silverado cup holder. 45.00
http://www.michiganspeed.com/dreamer.../cupholder.jpg

NBS Silverado dash bezel. Perfect. 45.00
www.michiganspeed.com/dreamer1q/selling/dash.jpg

1994 Camaro convertible stock fuel pump with 43k on it. Worked fine, upgraded to a Walbro. Gotta be worth 40 bucks I would think.
www.michiganspeed.com/dreamer1q/selling/pump.jpg

Small little chrome breather. 10 bucks shipped.
http://www.michiganspeed.com/dreamer...g/breather.jpg

Thats it for now....more to come as I continue to clean out the garage.

Email actually works better too guys. dreamer1q@michiganspeed.com

Sinister95Z

Would you be willing to seperate the Valence from the SLP Quad exhaust system?? It is the Center exit isn't it?

dreamer1q

I will not seperate. Please dont even waste your time asking.

Muncie4sp

is the tach 0-8k, 0-9k, 0-10k, or 0-11k?

dreamer1q

0-10k.

I will have pictures of most of this stuff hopefully tomorrow. Just dont have the motivation to do it tonight

87lt1rx7

the link for the chrome breather isnt working. is it a k&n or offbrand?? my airpump needs the performance lol

dreamer1q

Ok, pictures should be fixed. If for some reason one dosent work, you will find it here. www.michiganspeed.com/dreamer1q/selling

BlackLT1_TX

Prices seem way high to me, especially after checking the prices on those Autogage's

http://store.summitracing.com/defaul...=egnsearch.asp

So you going to sell a 28 dollar gauge (w/ free shipping now) for 45 + shipping, let me know how that works out for you.

dreamer1q

Two things, one I didnt check the prices on them. Second if your going to be a **** ***...go do it somewhere else. For you all prices are doubled. Now back to your hole troll

dreamer1q

bump for non idiots

JasonD

And THIS is why we made this rule, which applies to everyone...

It is offensive and rude to people when you insult them while not even being interested in what they have for sale. They get offensive and rude back, which is not pretty. Case in point.

I know the seller and even though he has a rotten attitude, he is an honest seller.

WETPAVEMENT

if you ever become interested in selling one of the front air dams I'd be very interested. I hardly ever get on anymore so if you want to seperate please call me at 319 520 8835. Name is Steve.... thanks

dreamer1q

Thanks Jason.....I am kinda a grump huh Its my new years resoultion to be nicer, honest


Yeah, I will accept offers, I just want to move this stuff and gave everyone a place to start.

blown383

Any of the stuff still for sale?

-B

dreamer1q

Most of it. Ground Effects are gone, along with the exhaust, vac can, and the headers are all gone. Rest of the stuff I still have. What cha need