Vortec small block heads and intake
Thread Starter
Registered User
Joined: Jun 2004
Posts: 1,066
From: Odessa/Lubbock, Texas
Vortec small block heads and intake
If any one is looking for some traditional small block stuff, I've got some Vortec heads and matching edelbrock intake for sale.
Heads are Vortec, and have had several things done to them. The spring pockets have been enlarged to accept bigger springs and the guide bosses have been cut down to allow larger lift cams, they have had ARP screw in rocker studs installed and Comp springs, I forgot what spring I had put on them but I do know that they were good to at least .570 lift. and came with retainers and locks. The heads don't need to be rebuilt, they have less than 10,000 miles on them since all the machine work was done.
Intake is the Edelbrock performer RPM with the Vortec bolt pattern.
I'm looking for 500.00 for heads and intake, or 400.00 for the heads and 100.00 for the intake.
Heads are Vortec, and have had several things done to them. The spring pockets have been enlarged to accept bigger springs and the guide bosses have been cut down to allow larger lift cams, they have had ARP screw in rocker studs installed and Comp springs, I forgot what spring I had put on them but I do know that they were good to at least .570 lift. and came with retainers and locks. The heads don't need to be rebuilt, they have less than 10,000 miles on them since all the machine work was done.
Intake is the Edelbrock performer RPM with the Vortec bolt pattern.
I'm looking for 500.00 for heads and intake, or 400.00 for the heads and 100.00 for the intake.
Thread
Thread Starter
Forum
Replies
Last Post
dbusch22
Forced Induction
6
Oct 31, 2016 11:09 AM