Cleaning out the basement and need to get rid of this stuff. Send me a PM or email or just reply for more info.
F-Body parts (all from a 1997 Formula vert unless specified otherwise)

Grey steering wheel w/ radio controls that worked when the wheel was removed –paint is peeling off buttons; no airbag
Complete steering column w/ knuckle (01 Trans Am) –small crack in plastic trim where the column goes into the dash, hard to see.
The vacuum chamber thing that mounts up under the front of the frame on the passenger side (01 TA)
Grey windshield pillar trim piece (01 TA)
LS1 AC evaporator (01 TA)
Stock grey seat covers –no headrests
Stock torque converter
LS1 rear brake rotors
Stock tunnel brace— X-shaped since it is for convertibles
Stock exhaust manifolds and catted y-pipe –1 broken stud where the y-pipe bolts to the passenger side manifold
Stock rocker arms and lifters – 100k miles
Stock 97 LT1 cam –100k miles
LS1 rear caliper mounting brackets
Stock LS1 K-member
Stock LT1 catback w/dual-dual formula tips –had to cut the pipe before it goes over the axle and where it goes into the muffler because it wouldn’t come out. Muffler and exits are all fine and intact if you just want that.
Windshield washer reservoir (01 TA) no cap
4th gen F-body wheel wells and complete air dam plastic
LS1 axles w/ longer studs
4th gen PCM mounting bracket

Other:
94-03 S10/sonoma altezza taillights
Volant cold air intake for 96+ s10/blazer/sonoma/jimmy 4.3L v6 (this one http://www.stylinconcepts.com/part....1&CategoryID=28)

Parts from a 1979 Oldsmobile 350
Fan
Alternator –includes mounting bolts; operating condition unknown, the car it came from sat for a few years but the motor was still in the car so it stayed dry as far as I know
4-barrel carburetor
Power steering pump
Accessory brackets (I believe all are there but let me know if you want an individual one and I’ll see if I can find it)

I also have a harmonic balancer that came off of an Olds rocket 350 that was in a 1971 cutlass. That was not the original engine in the car so I cannot promise the year of the motor but I would imagine that it would fit most olds 350’s of that time.

 

1968-1972 Olds 350 2-piece intake manifold gasket
Olds 350 gold valve covers--10 hole, need paint
79 Olds 350 thermostat cover
79 Olds 350 exhaust manifolds: Passenger--563619, broken bolt where it connects to crossover pipe from driver side
driver: 380001, broken bolt at exhaust pipe connection

 

Ttt

 

i need the wheel well plastics for the driver's side front wheel...send pics to ihatericer5hit@hotmail.com

thanks!

 

I'll get some pics to ya as soon as I can.

 

bump