Selling my SLP cold air induction, black powdercoated, good condition for 94-97 lt1 fbody. Comes with both k&N filters and plastic mounting plate. Good for an advertised 20 hp over stock. There are minor scratches in the paint where one tube rubbed against the ABS block, not visible when installed. This is made of stainless steel, powdercoated black. Paint can be stripped and the unit polished if you wanted the polished SS look instead. Only selling because I just switched to a lid setup.

$150 shipped in the lower 48, paypal only unless local p/u

(new is $280 from SLP)

http://www.fquick.com/garages/viewga...wimg&id=309548
http://www.fquick.com/garages/viewga...wimg&id=309549

Also selling a Spohn extreme duty steel driveshaft, stock length, for 93-02 fbody. I had some vibration at high speeds (over 80-90 mph) it may need rebalancing. I used it for a few months then decided to switch to an aluminum ds for less rotating mass, thought it was probably overkill for my setup.

$150 shipped in the lower 48, paypal only unless local p/u

(new it is $360 from spohn)

http://www.fquick.com/garages/viewga...wimg&id=309550
http://www.fquick.com/garages/viewga...wimg&id=309551
http://www.fquick.com/garages/viewga...wimg&id=309552
http://www.fquick.com/garages/viewga...wimg&id=309553

 

Bump

 

SLP cai SOLD!

 

driveshaft is SOLD!!!

Thanks all