for sale- moser 9" rear end best of everything,like brand new- for sale
#1
for sale- moser 9" rear end best of everything,like brand new- for sale
moser 9" outa 1996 camaro stock length
35 spline gun drilled axels with star flanged ends, 1/2 wheel studs
alumin center section
steel spool
3:70 street gear
extra fill hole for easy filling (fluid)
moser 1350 yoke end
has BMR brackets already welded on for anti roll/sway bar
WILL BOLT RIGHT IN AND GO CAN GO 8SEC WITH THIS SETUP
i have around 3200 in this 9" i am asking 2650 shipped. GET NO STRONGER
this was in my 9sec street car has around 2k on it and is like new
LOCATED IN, NW INDIANA 30MINS, FROM CHICAGO
35 spline gun drilled axels with star flanged ends, 1/2 wheel studs
alumin center section
steel spool
3:70 street gear
extra fill hole for easy filling (fluid)
moser 1350 yoke end
has BMR brackets already welded on for anti roll/sway bar
WILL BOLT RIGHT IN AND GO CAN GO 8SEC WITH THIS SETUP
i have around 3200 in this 9" i am asking 2650 shipped. GET NO STRONGER
this was in my 9sec street car has around 2k on it and is like new
LOCATED IN, NW INDIANA 30MINS, FROM CHICAGO
#13
haha yea...wish I could get it, just bought my transmission and it set me back enough.. I would trade the engine I have for it. Lt1 355 with rotating assembly and splayed billet mains. Had the block done and it is sitting in an oil bag in my garage ... I know you need hard cash though.. oh well.... rock on
#14
hey
haha yea...wish I could get it, just bought my transmission and it set me back enough.. I would trade the engine I have for it. Lt1 355 with rotating assembly and splayed billet mains. Had the block done and it is sitting in an oil bag in my garage ... I know you need hard cash though.. oh well.... rock on
also sale kinda pending