Possible Part Out of 1994 Z28 Camaro
Thread Starter
Registered User
Joined: Jan 2013
Posts: 4
Possible Part Out of 1994 Z28 Camaro
I have a 1994 Z28 Camaro with the LT1 and 6 speed T56 Transmission that I am looking to part out. I have more money invested into the car than I think I can sell the car for. If I get enough interest in the parts i will part it out, if not i'm not going to waste my time and will sell it complete, hurts to see it go but family is more important. Please no low balling but throw me offers on the parts as i haven't checked on a lot of prices lately.
-LT1 5.7 guy before me said it was ported and polished and gasket matched. Has Ford Racing 72 Lb Fuel injectors 10.8 mm Wires, New Water Pump, New Opti Spark, has A/C and power steering delete panels on it however still have the stock parts.
-T56 6 Speed Tranny with $750 Stage 3 Spec Clutch and Aluminum Pressure Plate and new throwout bearing.
-Spohn Tubular K Member
-Spohn Tubular Rear Control arms and Panhard Bar
-Spohn Pinto Manual Rack and Pinion Set up
-Mac Mid Length Headers with Y Pipe.
-4 inch pipe going to borla exhaust with dual outlets with dual 4 inch Flowmaster Tips
-2 black leather racing seats and 4 point harnesses
-Big Block Ram Air Hood with Ram Air box and K&N Intake
-Venice Body Kit
-Wings West Super Style Spoiler
-3 10 spoke camaro rims
-Have all body parts and interior parts, Just let me know what you are looking for.
-All aftermarket parts are basically brand new, only been on car for a few hundred miles.
Car can be seen at the following link, if interested in complete car throw me an offer, have not removed anything from the car yet. http://yuma.craigslist.org/pts/3526078992.html
-LT1 5.7 guy before me said it was ported and polished and gasket matched. Has Ford Racing 72 Lb Fuel injectors 10.8 mm Wires, New Water Pump, New Opti Spark, has A/C and power steering delete panels on it however still have the stock parts.
-T56 6 Speed Tranny with $750 Stage 3 Spec Clutch and Aluminum Pressure Plate and new throwout bearing.
-Spohn Tubular K Member
-Spohn Tubular Rear Control arms and Panhard Bar
-Spohn Pinto Manual Rack and Pinion Set up
-Mac Mid Length Headers with Y Pipe.
-4 inch pipe going to borla exhaust with dual outlets with dual 4 inch Flowmaster Tips
-2 black leather racing seats and 4 point harnesses
-Big Block Ram Air Hood with Ram Air box and K&N Intake
-Venice Body Kit
-Wings West Super Style Spoiler
-3 10 spoke camaro rims
-Have all body parts and interior parts, Just let me know what you are looking for.
-All aftermarket parts are basically brand new, only been on car for a few hundred miles.
Car can be seen at the following link, if interested in complete car throw me an offer, have not removed anything from the car yet. http://yuma.craigslist.org/pts/3526078992.html
Last edited by JayandDany; Jan 6, 2013 at 09:04 AM. Reason: addition
Thread
Thread Starter
Forum
Replies
Last Post