Hey Guys,

Well i am selling off everything, i have all the right parts here to make a 600-1000hp car all hi-end parts SO PLEASE NO LOW BALLERS

This is off my 95 T/A

I HAVE PICS OF EVERYTHING I WILL POST OR I CAN EMAIL THEM

Vortech cog pulleys 36mm, 78 teeth crank/30 blower

custom 4" suck side and air filter

vortech mondo BOV

Alky control kit
singal kit & new dual kit as well, with an new extra pump $440

Nitrous Outlet elbow for Vic intake i will through this in with the heads and intake

Vic Jr intake with fuel rails its fully ported and matched to the heads this stuff is a one off
matching AFR 220 heads
These are Z8's old AFR heads(220) that were ported by GTP that flow 330cfm@.600 and mating Vic intake you will not find another set of heads like this with shaft mounts 1.7r $3000.00

Qa1 for the front (newish) with 250lbs springs and shims $275

sphoon TQ arm $375

short block 355.....blower/nos set up
eagle rods 4340
eagle 4340
Je blower pistions
4 bolt main
balanced
ATi extra keyed crank
e-water
custom Bret B blower cam
Morrel's lifters

MAKE OFFERS ON ENG OR I CAN PART OUT


9" from DLS
35 spline axles
detroit locker
drive shaft for M6 tranny to match up with the 9" to handle 1000hp $2000.00

weld wheels
15x5 front with tires
15x10.5 with 7.5 bs and hoosher slicks $600

NEW MSD DIG 6 NEW 275.00

IF DOING PAYPAL ADD 3%

obo

 

pics of Weld wheels to mavericksis@yahoo.com please

 

What Welds are they?

Would you sell the heads alone? Im serious this time. Could you emal me pics of them again,? I cant find the other ones, that you sent me. Thanks!

ruqwiker2@yahoo.com

 

they are the pro star's 15x5 for the front
15x10 for the rear with 5.5 back spacing ?? off the top of my head
i have all the shims
i have all new weld wheel nuts for the rims..

i will email you pics of the heads and we can talk

 

pics of heads and intake to ianightmare@aol.com

 

ttt

 

ttt

 

Which QA1's are they? Can you send me pics to zmanlt1@aol.com

 

send me pics and specks on 9 inch...brand width center section ect