Hey Guys,

Well i am selling off everything, i have all the right parts here to make a 600-1000hp car all hi-end parts SO PLEASE NO LOW BALLERS

This is off my 95 T/A

I HAVE PICS OF EVERYTHING I WILL POST OR I CAN EMAIL THEM

Vortech Ysi Z8's brackets , with my custom 4" suck side and air filter
cog pulleys 36mm, 78 teeth crank/30 blower
8 rib pulleys 8" crank pulley with spacers/ 2.65 blower pulley with belt
FMIC and all the piping with extra clamps and hose
vortech mondo BOV

or i can split SOME OF THIS UP

Alky control kit
singal kit & dual kit as well, with an extra pump $450

Nitrous Outlet elbow $275

Vic Jr intake with fuel rails its fully ported and matched to the heads this stuff is a one off
matching AFR 220 heads
These are Z8's old AFR heads(220) that were ported by GTP that flow 330cfm@.600 and mating Vic intake you will not find another set of heads like this with shaft mounts 1.7r $3200.00

RACETRONIX / LONNIES PERFORMANCE Double Pumper kits - - Will support OVER 1000RWHP
$500 with the wiring kit from racetronix

upper/lower A arms BMR/Sphon $450 (new)

front Qa1 with 250lbs springs and shims $300

sphoon TQ arm $400

sphoon SFC CM $175 (new)

short block 355.....blower set up
eagle rods 4340
eagle 4340
Je blower pistions
4 bolt mail
balanced
ATi extra keyed crank
e-water
custom Bret B blower cam
Morrel's lifters (new)--------------$3000 or can part out the parts


9" from DLS
35 spline axles
detroit locker
drive shaft for M6 tranny to match up with the 9" to handle 1000hp $2500.00

1 3/4 jethot LT header with Y-pipe $350
2 magnaflow cats new $150
borla cat back with adj plate $400

Canton LT1 Valve Covers $175 new

weld wheels
15x5 front with tires
15x10.5 with 7.5 bs and hoosher slicks $600



IF DOING PAYPAL ADD 3%

obo

 

ttt

 

ttt

 

will those headers fit any year lt1?

 

how much for the rotating assy.? and what size dish are the pistons? are they JE for sure, or SRP (2618 or 4032 alloy)?

also id like some pics of the alky kit. ill pm you my address

 

hey do you have any stock exhaust manifolds? email me @ evilawd4g63@aol.com if you do

 

Even with the new thread, you still have my attention

 

headers are on hold as of now

 

it would be the short block....23cc JE blower pistons

there is pics of the alky kit in my sig

 

no sorry

 

think i have my home computer fix....will send out some pics where would you like them again

 

can i get more info on the spohn a arms? color? material? ball joints?

 

Jeremy, shoot me some more detailed info on the dual walbro setup:

jrbellas95z28@yahoo.com

 

k ......

 

what are you asking for the vortech setup.