I got this 3" chrome moly drive shaft with 1350 front yoke for a TH400 with short tail housing and 1350 rear u-joint. It was in a 96 Camaro with a 9" rear.
It was believed to fit my car by mistake - but mine is a 4L60E.

Same with the flexplate - it's SFI 168 tooth, zero balance for internal engines.
It will fit a TH400 bell housing, dual convertor bolt patterns and an LT1/4 crank.

Who built them? I do not know. The flex is a gold irridated look, has an SFI sticker but no brand markings.
The shaft has no sticker or markings.

Condition: the d/s is just dirty from oil, the front yoke is beefy and nice, the rear joint lost an end cap during shipping. Get a u-joint and put it in the car.
The flexplate has nice teeth, is clean and looks fine.

check my feedback on ls1tech and ebay - same user name.

I paid $250 shipped - let's start there.

Pictures if you're ready to buy based on seeing the parts - no suprise as to what they look like

please reply here or email - my pm box is always near full.
thanks!
jplatt02@snet.net

 

for the night crowd