Hello, Selling my converted Vortec Super Vic fitted to bolt on to an LT1/LT4 engine. I have added the extra 4 bolt holes on the inner runners, ported to Felpro 1206 intake gasket and the runners have been jack-knifed to increase runner length, along with the walls of the plenum pulled back. The Elbow fits under a STOCK LT1 setup/cowl, NO CUTTING, ready to bolt on to a LT1 TB.
Thermostat Housing removed, along with the rear distributor Plugged, PCV port under plenum.

PICS Below
I have over $800 in this setup, I will take $550 Shipped to your door

 

Are the rails include as well? Also it's hard to tell from the pics: do you need beveled washers under the intake bolts or is it already machined to the correct angle.

If it includes the rails and will bolt up to an LT1/LT4 I'll take it.
Thanks!

 

Of course the rails come with it, they had to be cut and rewelded, but they work perfect, painted/powdercoated black. I use beveled washers with a flat washer below it, Seals perfect even under my boost setup.

 

Sounds good -- I'll take it. I'll PM you my info.

 

Sale pending payment