LT1 Stock and Performance Parts
Thread Starter
Registered User
Joined: Jun 2005
Posts: 129
LT1 Stock and Performance Parts
Stock Parts
95 LT1 Radiator- This is a stock GM radiator out of a Z28 camaro.
It is in great shape and has no damage at all.
$150
95 SRS ECU - This is the Air Bag ECU that is located in the passenger
kick panel. This needs to be replaced if the bags have went off. In
perfect condition.
$20
Power Steering Pump - This is the factory power steering pump for a
LT1. It is in great working condition.
$30
Driveshaft - This is the stock steel driveshaft in a LT1 Auto car. It
has brand new Precision U-Joints in it about 30 miles ago.
$50
Front and Rear Sway Bar - Stock Sway bars in good condition.
$25
Polyurethene Motor Mount - This is a Energy Suspension Polyurethene
motor mount for the passenger side of the motor.
$20
M55 Oil Pump - This is a melling standard pressure SBC Oil Pump. It
has never been used. Had it from another project and ner used it.
$10
Performance Parts
MSD Distributor - This is a MSD Pro Billet Distributor 8570 for a SBC.
It has an adjustable slip collar, small diameter cap and rotor for
tight clearence and a Comp Cams Composite Gear designed for steel cams.
$200
Aeromotive Fuel Pump - This is the Aeromotive SS Series Fuel Pump, it
is designed for up to 750hp on a carburated motor and has less than
1000 miles on it.
$125
Painless Relay Kits - I have Painless Relay Kits for a Fuel Pump,
Water Pump, and 2 fan relays. Like new with all wiring.
$20 each.
Edelbrock Intake - This is an Edelbrock Super Victor intake for a SBC,
it has the 4500 dominator carb opening. Great for top end power. Mint
Condition.
$150
VFN Hood - This is a VFN Custom Hood for 93-97 Camaros. It has a 4.5"
Cowl and come as close to the windshield as possible and clears the
wipers. It was painted with the same red paint that comes on Camaros
at a local body shop. Requires Zues fateners to be mounted. Pics Avaliable.
$400
Battery Relocation - This is the Allstar Battery mount for the spare
tire well. As well as the Painless Batter Relocation 0 guage Power and
Ground wires. The Power wire is over 20ft and the ground is about 4ft.
$60
Spark Plug Wires - This is a set of MSD Super Conductor wires for a
standard SBC. Includes all 8 plug wires and the coil wire.
$50
LT1 02 Extenders - These are extension wires that are required when
using headers, they are used to connect the 02 sensors when they are
relocted on long tube headers. Both Left and Right Exentsions.
$30
Speedo Interface - This is a Dakota Digital Speedo Signal Interface. It
is used between the electric speedo sensor on the transmission and
the electric guage in the car. It let you use a TH400 tranny with the
stock guages and recalibrates for gears and tire size.
$45
Oil Pump Pick-Up - This is a Canton Oil Pump Pick-Up for a M55 Oil
Pump and there Oil Pan. This was for another project that never was
used.
$10
Transmission Cooler - This is a B&M Super Cooler with 24000GVW of
cooling. It is in great shape but I am getting one with a built in fan.
Comes with all the necessary hardware to install it.
$30
4000 Stall Converter - This is a 4000 Stall Anti-Balooning Torque
Converter for a 700R4. It was bought out of a place in Florida. It is
a great converter with no slipage in the top end of the 1/4 mile. The
Anti-Balooning plate is used to protect the engine during nitrious use
or incase a cooler line gets crimped and heat expands the converter it
won't damage the engine. Great Condition, less than 1000 miles.
$350
All items are priced before shipping. Shipping costs will depend on
zip code. I will also accept resonable offers.
95 LT1 Radiator- This is a stock GM radiator out of a Z28 camaro.
It is in great shape and has no damage at all.
$150
95 SRS ECU - This is the Air Bag ECU that is located in the passenger
kick panel. This needs to be replaced if the bags have went off. In
perfect condition.
$20
Power Steering Pump - This is the factory power steering pump for a
LT1. It is in great working condition.
$30
Driveshaft - This is the stock steel driveshaft in a LT1 Auto car. It
has brand new Precision U-Joints in it about 30 miles ago.
$50
Front and Rear Sway Bar - Stock Sway bars in good condition.
$25
Polyurethene Motor Mount - This is a Energy Suspension Polyurethene
motor mount for the passenger side of the motor.
$20
M55 Oil Pump - This is a melling standard pressure SBC Oil Pump. It
has never been used. Had it from another project and ner used it.
$10
Performance Parts
MSD Distributor - This is a MSD Pro Billet Distributor 8570 for a SBC.
It has an adjustable slip collar, small diameter cap and rotor for
tight clearence and a Comp Cams Composite Gear designed for steel cams.
$200
Aeromotive Fuel Pump - This is the Aeromotive SS Series Fuel Pump, it
is designed for up to 750hp on a carburated motor and has less than
1000 miles on it.
$125
Painless Relay Kits - I have Painless Relay Kits for a Fuel Pump,
Water Pump, and 2 fan relays. Like new with all wiring.
$20 each.
Edelbrock Intake - This is an Edelbrock Super Victor intake for a SBC,
it has the 4500 dominator carb opening. Great for top end power. Mint
Condition.
$150
VFN Hood - This is a VFN Custom Hood for 93-97 Camaros. It has a 4.5"
Cowl and come as close to the windshield as possible and clears the
wipers. It was painted with the same red paint that comes on Camaros
at a local body shop. Requires Zues fateners to be mounted. Pics Avaliable.
$400
Battery Relocation - This is the Allstar Battery mount for the spare
tire well. As well as the Painless Batter Relocation 0 guage Power and
Ground wires. The Power wire is over 20ft and the ground is about 4ft.
$60
Spark Plug Wires - This is a set of MSD Super Conductor wires for a
standard SBC. Includes all 8 plug wires and the coil wire.
$50
LT1 02 Extenders - These are extension wires that are required when
using headers, they are used to connect the 02 sensors when they are
relocted on long tube headers. Both Left and Right Exentsions.
$30
Speedo Interface - This is a Dakota Digital Speedo Signal Interface. It
is used between the electric speedo sensor on the transmission and
the electric guage in the car. It let you use a TH400 tranny with the
stock guages and recalibrates for gears and tire size.
$45
Oil Pump Pick-Up - This is a Canton Oil Pump Pick-Up for a M55 Oil
Pump and there Oil Pan. This was for another project that never was
used.
$10
Transmission Cooler - This is a B&M Super Cooler with 24000GVW of
cooling. It is in great shape but I am getting one with a built in fan.
Comes with all the necessary hardware to install it.
$30
4000 Stall Converter - This is a 4000 Stall Anti-Balooning Torque
Converter for a 700R4. It was bought out of a place in Florida. It is
a great converter with no slipage in the top end of the 1/4 mile. The
Anti-Balooning plate is used to protect the engine during nitrious use
or incase a cooler line gets crimped and heat expands the converter it
won't damage the engine. Great Condition, less than 1000 miles.
$350
All items are priced before shipping. Shipping costs will depend on
zip code. I will also accept resonable offers.
Last edited by 95Zedder; Feb 20, 2008 at 09:33 PM.
Thread Starter
Registered User
Joined: Jun 2005
Posts: 129
green96ta
These are the real deal, I bought them from thunder racing. I will take 25 + shipping. Let me know what your zip code is for shipping cost.
JONEZ_Z
I tried to message you but you inbox is full. The fan relays are all rated at 30 amps. If you give me your email, I will send you some pics.
These are the real deal, I bought them from thunder racing. I will take 25 + shipping. Let me know what your zip code is for shipping cost.
JONEZ_Z
I tried to message you but you inbox is full. The fan relays are all rated at 30 amps. If you give me your email, I will send you some pics.
Registered User
Joined: Feb 2007
Posts: 567
From: Queens, New York
can i get pics of the calibrator to blindprofit44@yahoo.com
Registered User
Joined: Dec 2007
Posts: 37
pics of the hood to bm-06@hotmail.com
Registered User
Joined: Jul 2007
Posts: 198
From: Norton, MA
Do you have a pic of the fuel pump? The SS series is a fuel filter not a pump.
There is an A1000, Eliminator, Pro Series, Inline EFI, 700HP EFI and the Tsunami.
do you have a model #
gregory.vincent@comcast.net
Thanks,
Greg
There is an A1000, Eliminator, Pro Series, Inline EFI, 700HP EFI and the Tsunami.
do you have a model #
gregory.vincent@comcast.net
Thanks,
Greg
Registered User
Joined: Nov 2006
Posts: 29
Do you still have the sway bars? Send me an E-mail at jlhashbarger@hotmail.com .
Jim
Jim
Thread
Thread Starter
Forum
Replies
Last Post
oldschool
Parts For Sale
16
Feb 9, 2016 09:21 PM