LT1 single plain vic-E with rails
Thread Starter
Banned
Joined: Oct 2006
Posts: 4,970
From: Goochland, Va.
LT1 single plain vic-E with rails
http://cgi.ebay.com/ebaymotors/ws/eB...m=160308440954
I have a vic E I had on my car, it is port matched to a stock LT1 gasket. Ported also.
The bolt patern is kind of crude, I bought it from someone here and the bolt holes were just drilled out and a longer bolt used. It only uses the outside bolts, but it sealed fine, I also have some small aluminum plates to block off the injector holes, I did that and ran a carb on it.
Make an offer, I want it gone this week. I am staying carbed and want a good carbed intake. It has about $250 worth of portwork, the rooff of the runners have epoxy in them etc. to fit to the stock gasket. I ran a best of 128mph 1/4 with it and an average of 125-126.
The bolt holes are kind of crude like I said the way it was done, but it works and its proven. So take it for what it is.... make an offer and I will only take paypal
The fuel rails come with it also.
I have a vic E I had on my car, it is port matched to a stock LT1 gasket. Ported also.
The bolt patern is kind of crude, I bought it from someone here and the bolt holes were just drilled out and a longer bolt used. It only uses the outside bolts, but it sealed fine, I also have some small aluminum plates to block off the injector holes, I did that and ran a carb on it.
Make an offer, I want it gone this week. I am staying carbed and want a good carbed intake. It has about $250 worth of portwork, the rooff of the runners have epoxy in them etc. to fit to the stock gasket. I ran a best of 128mph 1/4 with it and an average of 125-126.
The bolt holes are kind of crude like I said the way it was done, but it works and its proven. So take it for what it is.... make an offer and I will only take paypal
The fuel rails come with it also.
Last edited by mdacton; Jan 5, 2009 at 09:00 PM.
Thread Starter
Banned
Joined: Oct 2006
Posts: 4,970
From: Goochland, Va.
Thread
Thread Starter
Forum
Replies
Last Post
dbusch22
Forced Induction
6
Oct 31, 2016 11:09 AM
chevroletfreak
LT1 Based Engine Tech
202
Jul 4, 2005 05:00 PM
