Hey guys i am posting this for a friend. I want to see if there is any interest in it. He has a powerdyne supercharger for an lt1 which is complete that he is asking $1500 O.B.O. for it. It is used, but runs great.

He also has a set of aluminum edelbrock lt1 heads that have about 500 miles on if that. I think they cost $1,100 new but he is open to offers on them.

If any of u guys are interested, just pm or reply and i will get u pics and any other info u need to no. Thanks.

 

nobody is interested??? if u have any interest i will get pics and more info. make sum offers?

 

Sent you a PM.

 

pm replied

 

 

bumpity bump to the top

 

Does it come with the fuel pump and igniton box? How many miles on it? Is it the 4.5 or 6 psi Kit?
Thanks

 

what model is that, and is that for lt1 vette or impala because the two powedyne units i owned in the past for f-bodys didn't look like that.

 

Yeah, you're right, that isnt the right bracket setup for an f-body, I have one. I'd say its for a vettebecause dont they sit on the top pass side of the engine?

 

I'm sorry guys! It is a b-body lt1! I thought it was all the same as long as lt1!

 

Have any use for a LT1 powerdyne setup for F-body??

I have a rebuilt Powerdyne blower with brackets for 93-97 Fbody
I bought the kit and had it rebuilt with the intention of installing it in my 69 Firebird (has a lt1) Unfortunately, I discovered it wont fit because where the brackets are (the blower wont clear the subframe)

Im thinking that the Impala brackets will raise the blower high enough that I will be able to install with the Impala brackets

 

Anyone ever make contact with this guy?

 

yes i am here. i really dont have time to rent the bracket out to u. u can buy the whole setup though.

 

I was actually willing to pay you to just make me a cardboard tracing of the bracket with holes, I have retrofitted a newer LT1 into my 1969 Firebird.
I bought a used powerdyne kit for a FBODY (93-97) and it wont clear my subframe, It appears that the Impala brackets would sit the blower much higher and would most likely fit on my car.

The issue at hand is spending ANOTHER 1000.00 just for a poke and hope situation. If I had a true to scale template, I could measure up and see if it would fit my car, In the event it would clear, I was planning on buying the kit.

It would have taken all of 10 min to take a piece of cardboard and layed the front bracket on it and traced out the bracket.

I understand that you dont have the time or want to be bothered.

Goodluck with your sale