Im selling these parts I'm not going to use. Prices do not include shipping. Please PM me with your zip and I%u2019ll give you a quote with shipping. Pm me if your interested in a package deal. All prices are obo but will not be lowballed. Im in Lenexa, KS if you would like to pick up or meet up. I accept money orders, cashiers checks, or paypal plus the 3%.


Arp 3/8th studs $20.00 the guideplates in the picture are gone



Speed pro hypereutetic pistons with coated skirts 4.030 diameter, ran but not long. coating still looks good. Mounted on gm rods, they look forged and deff not PM rods. 200? make an offer

k&n cai tube only, no filter and no sleeve for hooking up to maf. make an offer

borla tips, dirty but i bet they would clean up only got pic of one side. make an offer. also in the same pic is a steel driveshaft, needs u-joints make and offer



flowmaster 3.5" in 3.5" out with short turn down. guessing 10 series, smaller than a 40.

pacesetter coated long tubes, coating still looks good, couple scratches and bubbles, have highend (not cheap) v-bands welded on but can cut off. v-bands were 55.00 each and have a lip so they seal and wont ever leak. the other side of the band has never been welded on and the black around the end is old sealant from when i had a slip fit y-pipe $400



LT1 SS spoiler, red with some oxidation and the clear is bubbling a bit but otherwise in fantastic shape. 300



I also have some other odds and ends like lifter dogbones, factory oil cooler, rods, pistons, 1 stock bare block, 1 stock short blocks needs rebuild, 1 .030 block needs cleaned up and fresh hone, intakes, thottlebody, chrome ball milled short valvecovers centerbolt (they don't fit promags) and other misc engine stuff. make offers

 

Do you have pictures of the rods and pistons?

 

pm's sent/replied

right now:
cam pending
valve covers pending
coil/icm pending

 

bump!

cc502 sold

 

updated and to the top

 

still got headers?where are u located?