LT1 & LS1 stuff, 1LE elbow, 160d T-stat, chrome valve covers, etc...
07-02-2010, 02:57 PM
#1
Registered User
Thread Starter
Join Date: Aug 2009
Location: Stillwater, OK
Posts: 36
LT1 & LS1 stuff, 1LE elbow, 160d T-stat, chrome valve covers, etc...
Selling off my LT1 stuff that never got put on my '96 Z28 before I sold it, as well as the LS1 stuff that I am just now replacing on my '99 WS6...
Prices include shipping & Paypal fees! Let me know if you have any questions!
Stock LT1 air box with filter, but it's missing the cover! I believe it was like that on the car when I bought it. Maybe someone cut it off or something, idk. - $20
Stock LS1 throttle body. I just installed an LS6 intake & ported TB on my WS6, so this if from my stock setup. This is the TB only, with no sensors. - $50
Stock WS6 Ram Air lid & paper filter. This is literally just the top lid & clamp & filter. I cut up the bottom portion to get out the little sensor to install in my whisper lid.
Also, as you can see in the pic, the rubber part that clamps on to the TB is a little mis-shaped on the inside, fyi. - $20
Stock WS6 rear springs. Should fit any 4th gen Fbody, 93-02. - $40
I also have the complete stock WS6 exhaust (minus a section of the i-pipe) if anybody is interested. The cats are still on the y-pipe & the car had 128k when I removed everything. It all worked perfectly. local pickup on this stuff is highly preferred. If nobody is interested, I'll just scrap it all out.
PS I know I'm not a long time member, but I can provide you any info you may need. My Ebay user name is perrypoke, where I have tons of great feedback.
Thanks!
Prices include shipping & Paypal fees! Let me know if you have any questions!
Stock LT1 air box with filter, but it's missing the cover! I believe it was like that on the car when I bought it. Maybe someone cut it off or something, idk. - $20
Stock LS1 throttle body. I just installed an LS6 intake & ported TB on my WS6, so this if from my stock setup. This is the TB only, with no sensors. - $50
Stock WS6 Ram Air lid & paper filter. This is literally just the top lid & clamp & filter. I cut up the bottom portion to get out the little sensor to install in my whisper lid.
Also, as you can see in the pic, the rubber part that clamps on to the TB is a little mis-shaped on the inside, fyi. - $20Stock WS6 rear springs. Should fit any 4th gen Fbody, 93-02. - $40
I also have the complete stock WS6 exhaust (minus a section of the i-pipe) if anybody is interested. The cats are still on the y-pipe & the car had 128k when I removed everything. It all worked perfectly. local pickup on this stuff is highly preferred. If nobody is interested, I'll just scrap it all out.
PS I know I'm not a long time member, but I can provide you any info you may need. My Ebay user name is perrypoke, where I have tons of great feedback.
Thanks!
Last edited by osuhog; 07-21-2010 at 09:54 AM.
Thread
Thread Starter
Forum
Replies
Last Post
chevroletfreak
LT1 Based Engine Tech
202
07-04-2005 05:00 PM