I still have the following items for sale:

LT1 4 bolt bare block - this block has the endcaps. The block has been bored .030 over and was run for less then 3000 miles. It has a sleeve in #7 and a piston broke apart in #5 but it is usable. The cylinders look pretty good and at most they would need to be honed. This was used for a 383 stroker LT4 setup. Asking $200 and needs to be picked up

Eagle H-Beam ESP 6" rods - these rods have less then 1000 miles on them and are in perfect condition asking $350

LT4 intake - This is an GM LT4 intake with distributor hole drilled in the rear. This hole can be plugged up using a cap from the LT4 carb intake if not wanting to use a rear mount distributor. Asking $200

Canton LT1 high capacity oil pan. This pan has less then 3000 miles use and just needs to be cleaned. Asking $150

LT1 Extreme duty timing kit - Less then 3000 miles use. Asking $150

OBDII computer with LT1 Edit and cable asking $300

Crane hydraulic roller lifters $75

If there are any questions please email them to OrionSPL@comcast.net. Thanks!

 

Email'ed you about the block...

-Corey

 

"LT1 Extreme duty timing kit - Less then 3000 miles use. Asking $150"

Would this hold a CC306 cam? Would I have to switch to electric water pump with this? If not, let me know. I have a stock LT4 timing kit, now but I want something heavy duty cause of the cam.

Let me know by e-mail,

BIZ

 

LT1 edit - is it OBD1 or 2?

thanks

 

Crane hydraulic roller lifters $75
how many miles and how much lift are these good till

 

This is an OBD2 LT1 edit. I also have a Meziere electric water pump with LT1 housing that has been plugged. Asking $200 for it.

 

?????????

 

They have less then 3000 miles on them. The part number is 10530-16, I'm not sure what lift they are good too. Have to check it out.

 

got any pics

 

Interested in canton oilpan. E-mail me at xtreamtrans@yahoo.com if you still have it.