LS1 Aluminum Driveshaft removed from an 2001 SS. I bought it for my LT1 SS but have since decided to sell the car. I never installed the driveshaft
$130 shipped to the lower 48 States, thank you for your interest.

 

any idea on how difficult it is to install

 

All you have to do is remove the u-joint bolts from the rear end then slip the end of the driveshaft out of the tranny (can be a fluid shower) then just install the new driveshaft. You might want to also remove the tunnel brace to make the swap quicker.

 

can anyone else pitch in how much of a difference i will see going from my steel d/s to an aluminum

 

It's not going to work any miracles, it's going to lighten up the drivetrain obviously(less wear on the tranny), and its going to reduce the vibrations experienced at higher speeds. But hopefully others will provide their feedback to help you with your decision. Also if you are interested in purchasing it you could search the message board for aluminum driveshafts and see if you might find the information you are looking for

 

does it come with the yoke and u-joints?

 

Yup

 

any damage on them at all from install or uninstall?

 

None at all, no scratches on the shaft at all and it looks great!

 

happen to know the mileage on it? sorry about all the questions...

 

Honestly I do not, I purchased it from a friend that removed it from a 2001 SS, I have had it for over a year and he had it for at least 6 months before that so just with the timewise I would say it wasn't in the car for very long.

NOTE: The 2001 SS was not wrecked it was converted to drag only and the DS was removed to go with a different DS for a TH400

 

ttt

 

If you have it and accept Paypal I'll take it! I'll have to transfer funds to my Paypal account, but it should only take about three days. Let me know if this sounds good.

 

Sounds great, but it may already be sold. I will reply to this thread as soon as I know for sure. Thanks again for your interest

 

Sold