Low mile (56k) LT1-freshned up, now for sale
#1
Low mile (56k) LT1-freshned up, now for sale
Pics upon request of cylinder walls after I got back from machine shop. I took this block in on trade for some work I did and now it needs to go. i pulled it from the f body it came out of and will vouch for mileage claim.
Block has been tanked, and deglazed. Did not need to be bored so is still a standard bore. Pistons and rods were checked out and verified within tolerances. Block was also line honed and new cam bearings installed.
New main & rod bearings and piston rings. GM 847 grind cam, and the ported heads and intake off my setup with new valve springs and new valve stem seals. The heads and intake are still on my car now, but once I get payment they will be taken off, cleaned, and installed on to this bottom end.
I also have new timing chain/gear set for both style opti's so just tell me which one you have, and I will install it for you. $1,500 takes it all.
Block has been tanked, and deglazed. Did not need to be bored so is still a standard bore. Pistons and rods were checked out and verified within tolerances. Block was also line honed and new cam bearings installed.
New main & rod bearings and piston rings. GM 847 grind cam, and the ported heads and intake off my setup with new valve springs and new valve stem seals. The heads and intake are still on my car now, but once I get payment they will be taken off, cleaned, and installed on to this bottom end.
I also have new timing chain/gear set for both style opti's so just tell me which one you have, and I will install it for you. $1,500 takes it all.
Thread
Thread Starter
Forum
Replies
Last Post
PFYC
Supporting Vendor Group Purchases and Sales
0
01-23-2015 01:13 PM