ok heres what i got.
a pair or l98 aluminum heads ported, and machined to accept 2.00"/1.60" valves, milled, three angle valve job, and new spring seats to except double springs. The valves are Manley race flows. The springs are matched to the cam which is an Erson hydrolic roller that only needs to be polished (my machinest will do it for $40 bucks) roller lifters, aluminum roller rockers 1.6in 1.5 ex, a 10' locks and retainters, and a holley 750 vs. It would have been a sweet motor but, id rather spend money on the ss. I went with these heads because these are the heads that Ligenfelter use on some of his motors (check their web site for stats). Im only look to get what i paid, and i have all the reciepts to show for it. Heads machining $720, valves, 170, Heads, cam, roller rockers and lifters $600 (from brother). $1490 in total. Will throw in Tpi throttle body, and, intake manifold. I also have a 70 4 bolt sbc that need to be machined, with a cast crank, pinky rods, and trw 10:1 forged pistons for $200.