i am selling a new just placed on car never used hurst billet line lock pre plumbed for 3rd gen brake master set-ups but can be replumbed for any other car or system.

costs $110 new

asking $65 shipped

i accept paypal.

 

Hmm, sounds fun. Can you send pics? Does it come with the wiring and switch? Where does the switch go? schmidtj86@hotmail.com for pics.
Thanks!

BTW, installed and modified the harness (and pressure switch) for the 4L60 for use in a TPI car, but haven't been able to drive it yet. The rear end is still in pieces (and I'm out of the country as always).

 

Does it come with the lines to drop in right in place? If so, send me your Paypal address so i can pick it up.

I'm tired of wearing out my back brakes at the track!!!

Is the kit complete? I need the wiring and switch as well.

 

DOES NOT COME WITH WIRING OR SWITCH but will come with warning light all you will need is a simple on off switch and some wires to run power and ground thats all.

paypal addy is tumadre94@comcast.net

 

How hard would this be to put in a 4th gen?

 

you would have to make new lines and i am not to sure how to plumb it but i know there should be an installation instructions on there webpage.

$60 shipped

 

Still got it? I will paypal you $60 as soon as you respond to this post, or whenever i read it again.

Did you say it came with the brake lines? That could be a deal breaker, cause i have spare wiring and and a spare switch in my toolbox.

 

pm sent....

 

Back at ya. SOLD to me. Payment sent.

 

Sold