i have a hooker aerochamber muffler on my car, i want a flowmaster, or ill sell it so i could buy another, im not sure whats its worth so shoot me an offer.
its a single in dual out, looks like 3 in in and 2.5 in out. its in really good shape, just not the sound i like.

i also bought a lsi lid with the intentions of putting it on my car but lost the time. the rad support has been cut so it sits flush on the lt1 , u cant tell its been trimmed from the sides or the top, i didnt take anything visual off, just where the bolts go to hold it down had these huge spacers under it and i took those off so it wouldnt sit all raised up. the lid however is a stock lid, but i cut the resonators off, i havent fiberglased it shut yet but it could easily be covered with foil and tape and not look ghetto till you fiberglassed it or got an aftermarket lid
ls1 lid setup comes with
rad support, stock lid
and stock coupler things
and the air filter tray
offer away on the lid as well, or id trade partially or fully for a cai for a lt1. i really like the slp ones which is mainly what im searching for, or a moroso

stuff is located in nw arkansas or central ar

also have a 10 bolt with posi and brand new bearings fluid and seals, have receipts, out of a 94 with 3.73 gears. gears make slight noise, but it is quieting down, gears where installed by an idiot first who didnt replace a bad pinion bearing, the gjuy who i had reset the gears inspected them and said there was no reason to get new gears since these were perfectly fine wear-wise and re lined them up-hes a gm master tech so i trusted him. he still charged me 500 bucks to do bearings and seals and stuff, and like he said it is quieting down, but the gears were too low for me and my purpose.

300 bucks obo-i REALLY want it gone so can i stress OBO, please just offer, the rear end is in springdale arkansas but i can lug it down to school with me if someone will buy it.

pm me of 479-305-0870 u can text me