Gauging to see if there would be any interest in a Ford 9-inch. Here are the specs:
-Set-up for 4th gen but not complete: it needs the torque-arm mount.
-65" WMS to WMS.
-Has brackets for everything else including brackets for Lt-1 style disk brakes.
-31 spline axles have been redrilled for 5 on 4.75 bolt-pattern.
-Third member is assembled with 4.11 gears and a billet race posi from Randy's Ring and Pinion.
Looking to get $850 for everything but as stated, there is some fabrication required to fab a torque arm mount. Also, I can have Moser or Strange axles made and installed for about $400.
I am in Windsor, Ontario (right across from Detroit) but can deliver to Michigan.

 

Can also deliver to Ohio, or Buffalo area over Christmas break.