I am selling a set of heads that I have had laying around for a few years. I planned on putting them on my car, but money was never there to start the project.

GM casting number 10088113 (this casting was the better of the two on TPI cars), Aluminum head, 58cc, Angle Plug, Raised "D" exhaust port. They have guide plates and screw in studs also. From an 88 TPI vette that had around 30K on the clock. Heads have been sitting since mid 90's.

I am looking to get $500 for the heads but prices are negotiable.

I would recommend a valve job just to make sure they are all clean and not going to leak or burn oil, and resurfacing the deck just to make sure it is strait after sitting so long (I just had all that work done to a set of SBC heads and cost me $225). But that is all up to you. The car ran great before they were taken off, so I know that they are good.

If you want pics, email me at guy_z28@hotmail.com

 

Make an offer. No reasonable offer will be refused...I need $$$

 

Ill give you $350 shipped