FS: polished TPI setup, misc L98
FS: polished TPI setup, misc L98
I just found it’s going to be awhile before I get my tax return back, and I need some money for heads. All parts are off my 1988 GTA all prices are negotiable and + shipping. I will also trade for aftermarket heads, 58 mm throttle body, older laptop, ignition parts and maybe some others. I accept Pay pal and will ship COD if needed. I know my post count is low, I'm mostly active on www.ksfba.org and TGO.
1988 L98 TPI Intake: I just got done polishing this setup. It is absolutely beautiful. Mirror-like finish, especially on the runners (you can see across the room in the aluminum if you look close). Included is the base w/ new EGR valve, fuel rails w/ DIY AFPR, runners, thermostat neck, ported plenum w/ corvette extension, and all of the bolts. I’ll throw in some other little odds and ends as well such as the cold start injector, cold start coolant switch/sensor and my old manifold air temp sensor in the bottom of the plenum. $350 OBO.
L98 Injectors, 22lb. need new o-rings, work fine $40
Some other stuff that’s cluttering up my garage:
L98 Exhaust manifolds and y-pipe best flowing third-gen manifolds best offer (free?)/pickup only.
1988 L98 cam I think 207/213 dur. 117 LSA 415/430 lift, $30 OBO
AIR pump and misc. stuff free
Also I may be selling a 95+ s10 torque converter (~2200+ stall) in the next few weeks, taking offers.
for pics check out my ad on TGO:
http://www.thirdgen.org/classifieds/...tgo?adid=40648
1988 L98 TPI Intake: I just got done polishing this setup. It is absolutely beautiful. Mirror-like finish, especially on the runners (you can see across the room in the aluminum if you look close). Included is the base w/ new EGR valve, fuel rails w/ DIY AFPR, runners, thermostat neck, ported plenum w/ corvette extension, and all of the bolts. I’ll throw in some other little odds and ends as well such as the cold start injector, cold start coolant switch/sensor and my old manifold air temp sensor in the bottom of the plenum. $350 OBO.
L98 Injectors, 22lb. need new o-rings, work fine $40
Some other stuff that’s cluttering up my garage:
L98 Exhaust manifolds and y-pipe best flowing third-gen manifolds best offer (free?)/pickup only.
1988 L98 cam I think 207/213 dur. 117 LSA 415/430 lift, $30 OBO
AIR pump and misc. stuff free
Also I may be selling a 95+ s10 torque converter (~2200+ stall) in the next few weeks, taking offers.
for pics check out my ad on TGO:
http://www.thirdgen.org/classifieds/...tgo?adid=40648
Thread
Thread Starter
Forum
Replies
Last Post
detroitmuscle
Parts For Sale
0
Jul 31, 2015 04:21 AM



