FS: Nitrous Work LT1 Wet Plate Kit
Thread Starter
Registered User
Joined: Jan 2006
Posts: 1,127
From: Dallas, TX
FS: Nitrous Work LT1 Wet Plate Kit
This kit is the best-engineered kit for the LT1 powerplant. The freeze-free plate design is compatible with OEM engine components, however, a higher-powered ignition system is recommended. It does not require an additional fuel regulator or upgrade. Adjustable from 75 to 175 horsepower, the system is equally at home on the 1992-1996 Corvette, 1993-1997 5.7L Camaro and Firebird, or the 1993-1997 Impala SS.
Complete: Bolt-on spray bar plate, calibrated jets, solenoids, hose, filter, hardware, instructions, 14 foot/4 AN stainless bottle feed line, and a 10 pound bottle.
Complete: Bolt-on spray bar plate, calibrated jets, solenoids, hose, filter, hardware, instructions, 14 foot/4 AN stainless bottle feed line, and a 10 pound bottle.
4 AN Stainless Bottle Feed Line + Bottle Connector
10 Lb bottle 3/4 FULL
1 Fuel Solenoid
2 Nitrous Solenoids (1 is purge)
Fuel Pressure Safety Switch
Wiring
Jets 75-175
Throttle Body Plate
Throttle Body Bolts
Bottle Brackets
WOT Switch
Stainless Lines for solenoids
All mounting brackets
You will have to supply toggles which you can get at autozone, and I will also supply wiring diagram.
$400.00 OBO Shipped / $350.00 Locally
Michael 972-679-5322
Last edited by Mike96z; Jun 19, 2007 at 01:34 PM.
Registered User
Joined: Jan 2007
Posts: 119
From: Illinois
If I was you I would hook this up to your car and run the **** out of it. I had the same kit one my 94 camaro with vortech supercharger(motor was all stock on the inside and I didn't have no problems spraying the **** out of it)
Registered User
Joined: Mar 2004
Posts: 179
From: west Tennessee
