Selling a forged 396 rotating assembly, has Eagle 4340 crank, Eagle 6" H-beam rods, SRP flat top pistons, clevite bearings, and plasma moly rings. The assembly has been fully balanced and everything is new in original boxes. College is taking priority over the car, so I need to unload this. Asking $1250 shipped to the lower 48 states, cost for me was $1600 plus $270 balancing and $150 shipping.

 

that is exactly what i have been looking for. A few questions though: Any bearings come with the kit? What compression ratio with 58cc heads? And mainly out of curiosity...who'd you buy it from in the first place?

 

edit: Clevite bearings...gotcha

 

the pistons are -7cc valve relief, I do not know the compression ratio, however I am sure it will be at least 10:1.

 

Where did you get it? Maybe they can tell me compression ratio.

 

Combination Motorsports. the compression ration will depend on the deck height of the engine and the head gasket thickness used.

 

I will definately get back to you about this.

 

i,ll take it.
pm,d you
nick

 

My 396 set up with 3.875 crank-6 inch rods and 5cc SRP flat tops will work out to 12.2 to 12.5 CR with 58cc heads,I figure the 7cc should yield about the same!!

 

I replied to PM's and aplologize for pics, my digi cam was given a drop and slobber test by a 4 y/o and it failed both tests. as for the compression ratio it will depend on deck height on the block, the gasket thickness used and if you have heads that have a ported combustion chamber like AFR's or similar. but I will say this setup is designed to be N/A.

 

TTT, no camera yet

 

looking forward to completing this deal,..
nick

 

Ttt

have pic of kit and scanned balance sheet

 

Ttt

 

Ttt