-Cartek Stage 3 CNC Ported Heads. These have about 2000 miles on them and went 11.4's on motor in a 93 Vette. I bought AFR 220's and no longer need these.

Specs:
-Milled to give 11:1 compression ratio on stock motor
-Comp Cams Springs good to .550 lift
-Polished CC's
-Ferrea Valves 2.02 / 1.56
-NO rocker studs

$900 shipped

-93 CNC ported intake and fuel rail, $125 shipped
-Corsa Exhaust w/ Fully Polished Tips, $600
-Holley 52mm Throttle Body, CNC'd Billet Aluminum, Polished $300 shipped
-28# Flowmatched Injectors from TPIS, $200 shipped
-LS1 Aluminum Driveshaft $150
-BMR Torque Arm, red, $250
-Spohn Lower Control Arms, red, $90
-Spohn Panhard Rod $50
-95 Trans Am rear w/ 373 gears and all new bearings, ABS,No TCS,
1500 miles since install $300

I have pics of the heads/intake and I can get pics of anything else also. My email ischronicly@aol.com and everything is located in Maryland, right outside D.C.

Nick

 

hey just outta curiosity how much would it cost to send the rear end to 03874 all the brake hardware there disk or brake if disc and it can be sent somehow consider it sold still debating on throttle body

 

I will try to find out how much the rear weighs and check on the cost. I am putting my moser 9" in and I need to switch the brakes over, it is disc though. What is your e-mail??

Thanks, Nick

 

interested in the rear end. its posi right? what series carrier? what brand of gears were put in it?

 

The heads..... any flow sheet and or pics?

Thanks, Joe Joeb1320@yahoo.com

 

Can you send pics of the intake and holley T.B. abitaman2002@yahoo.com.

 

Is the panhard rod adjustable? If so I'm interested. Let me know.
wesleybarranger@hotmail.com
Thanks.
-Wes

 

checking to see if you still have the corsa exhaust. Are you firm on the 600 if you are willing to neg let me know. I have christmas and two bithday parties for my kids

 

94TA_LT1, it is posi and it originally had 3.23's so I think its a 3 series carrier? I put in the gears and install kit from SLP and its not noisy at all. I will get some pics for you this weekend.

I will send e-mail to everyone else.

Nick

 

I would like pics of the intake & fuel rail too
smrtprts@pacbell.net

 

Ttt

 

I am interested in the heads. I need to know a few things but I have cash ready to go for the heads, intake and possibly fuel rails. He!!, maybe the injectors to.

Please e-mail me at madelisle@yahoo.com if they are still available, thanks!