FS - JBA Headers, 1LE AC, Fuddle Stall, TF Elbow, LS1 Spindles, Mats, + More
Thread Starter
Registered User
Joined: Jul 2002
Posts: 1,193
From: San Diego, CA
FS - JBA Headers, 1LE AC, Fuddle Stall, TF Elbow, LS1 Spindles, Mats, + More
Lt1 and LS1 Parts
Decided to clean out my garage/storage shed and have a bunch of parts to sell. I have or can get detailed pictures of everything. Email me at snvent(at)gmail.com, PM or post here for pictures or more info. Prices are somewhat negotiable for some items.
Trickflow Elbow - Powder Coated Quazar Blue - $70 Shipped = Sold
This brand new elbow came with my intake manifold and was powder coated quazar blue. It comes with both rubber hoses but not the clamps (they can be purchased at a hardware store or through summit). While the powercoating looks nice, it is not show car quality. It came out with a few bubbles (I have pictures of this). I am selling because I will be going to an LS1 style Lid and have no need for it.
Custom Floor Mats from www.F-Bodycarpet.com - $110 + Split Shipping
These floor mats are brand new in the box and have never been in the car. I purchased them maybe 2 years ago, but my car has since evolved into a drag car. They are top of the line floor mats for any camaro. There are 4 mats (front and rears) that are made with 1500 series carpet and custom embroidered with "Z28" on the front two. They are Dark grey with black embroidery. 1500 hundred series carpet is the thickest pile carpet you can purchase for a vehicle as standard capet is 600-700 per square inch. The carpet is thick enough to stand a quarter up in. I have 7 pictures of the mats. The mats were $150+Shipping.
1LE AC delete pulley - $35 + Shipping = Sold to DERBS
This is a relatively new GM 1LE pulley. I removed because I relocated my alternator down low. The pulley works fine but has slight knicks in the plastic pulley from when I lost a belt at the track. I can get pictures of this and have pictures of the pulley.
Almost new Kragen belt tensioner - $20 Shipped
Purchased this and found the tensioner was not the problem causing my belt squeal (it was the alternator). Relocated the alternator and have no need for the new stock tensioner. Used for maybe 5 miles/5 passes. Cost like $50 new.
LT1 T56 6speed pedals - $50 plus shipping = SOLD to Aaron
Swapped to a th400 and they are left over. Work fine but have no use for them. Perfect for completing your 6spd swap.
LS1 Front Spindles - $75 + Shipping
Somebody has to need these for a swap. Work fine, no problems at all.
Fuddle 3600 Stall for th400 (Performance Series) - $350 + shipping
This converter is brand new and has never even had an input shaft in it. Changed my setup and have no need for this converter. Setup for a big hit of nitrous. Recieved on 11/22/06 so there is plenty of warranty left (they offer a 2 yr warranty). Will work with any th400 LT1 or th400 SBC. Can get into specifics and setups that this will work with in detail if needed.
Stock LT1 Brakes Front and Rears - Make an Offer
Pulled them off the car to swap to LS1 brakes. They are in perfect working condition.
Stock 6spd Flywheel and A4 Flexplate - Make an Offer
I have a stock flywheel that needs resurfacing but is otherwise fine. Switched to a th400 and have no use for it. Also have an A4 flexplate from when the car was stock. No problems with either.
TCI SFI Approved Flexplate shield - $40 + Shipping
I purchased this to make my 4thgen legal, but it needed extensive clearencing. I decided not to do this work and have no need for it now. It is brand new and should fit any sbc with enough firewall clearance.
97-99 C5 JBA Smog Legal Stainless Steel Headers - $500 + Shipping
These are brand new CARB legal 1 3/4 primary Stainless Steel headers. They are new in box and have never been on a car. Purchased for my C5 but have since decided to sell it. They are $750 without shipping when purchased new.
I can email pictures of anything needed. I can accept paypal and money order. PM, Email or post comments or questions. Snvent(at)gmail.com I will probably add some more parts to this post when I get a chance.
Thanks for looking
Decided to clean out my garage/storage shed and have a bunch of parts to sell. I have or can get detailed pictures of everything. Email me at snvent(at)gmail.com, PM or post here for pictures or more info. Prices are somewhat negotiable for some items.
Trickflow Elbow - Powder Coated Quazar Blue - $70 Shipped = Sold
This brand new elbow came with my intake manifold and was powder coated quazar blue. It comes with both rubber hoses but not the clamps (they can be purchased at a hardware store or through summit). While the powercoating looks nice, it is not show car quality. It came out with a few bubbles (I have pictures of this). I am selling because I will be going to an LS1 style Lid and have no need for it.
Custom Floor Mats from www.F-Bodycarpet.com - $110 + Split Shipping
These floor mats are brand new in the box and have never been in the car. I purchased them maybe 2 years ago, but my car has since evolved into a drag car. They are top of the line floor mats for any camaro. There are 4 mats (front and rears) that are made with 1500 series carpet and custom embroidered with "Z28" on the front two. They are Dark grey with black embroidery. 1500 hundred series carpet is the thickest pile carpet you can purchase for a vehicle as standard capet is 600-700 per square inch. The carpet is thick enough to stand a quarter up in. I have 7 pictures of the mats. The mats were $150+Shipping.
1LE AC delete pulley - $35 + Shipping = Sold to DERBS
This is a relatively new GM 1LE pulley. I removed because I relocated my alternator down low. The pulley works fine but has slight knicks in the plastic pulley from when I lost a belt at the track. I can get pictures of this and have pictures of the pulley.
Almost new Kragen belt tensioner - $20 Shipped
Purchased this and found the tensioner was not the problem causing my belt squeal (it was the alternator). Relocated the alternator and have no need for the new stock tensioner. Used for maybe 5 miles/5 passes. Cost like $50 new.
LT1 T56 6speed pedals - $50 plus shipping = SOLD to Aaron
Swapped to a th400 and they are left over. Work fine but have no use for them. Perfect for completing your 6spd swap.
LS1 Front Spindles - $75 + Shipping
Somebody has to need these for a swap. Work fine, no problems at all.
Fuddle 3600 Stall for th400 (Performance Series) - $350 + shipping
This converter is brand new and has never even had an input shaft in it. Changed my setup and have no need for this converter. Setup for a big hit of nitrous. Recieved on 11/22/06 so there is plenty of warranty left (they offer a 2 yr warranty). Will work with any th400 LT1 or th400 SBC. Can get into specifics and setups that this will work with in detail if needed.
Stock LT1 Brakes Front and Rears - Make an Offer
Pulled them off the car to swap to LS1 brakes. They are in perfect working condition.
Stock 6spd Flywheel and A4 Flexplate - Make an Offer
I have a stock flywheel that needs resurfacing but is otherwise fine. Switched to a th400 and have no use for it. Also have an A4 flexplate from when the car was stock. No problems with either.
TCI SFI Approved Flexplate shield - $40 + Shipping
I purchased this to make my 4thgen legal, but it needed extensive clearencing. I decided not to do this work and have no need for it now. It is brand new and should fit any sbc with enough firewall clearance.
97-99 C5 JBA Smog Legal Stainless Steel Headers - $500 + Shipping
These are brand new CARB legal 1 3/4 primary Stainless Steel headers. They are new in box and have never been on a car. Purchased for my C5 but have since decided to sell it. They are $750 without shipping when purchased new.
I can email pictures of anything needed. I can accept paypal and money order. PM, Email or post comments or questions. Snvent(at)gmail.com I will probably add some more parts to this post when I get a chance.
Thanks for looking
Last edited by tireburnin; Jun 9, 2007 at 06:01 PM.
Thread Starter
Registered User
Joined: Jul 2002
Posts: 1,193
From: San Diego, CA
They are an almost steel grey close to the color and LS1 uses compared to the grey and LT1 uses. As for the model they are made to fit 93 - 02 camaros. They are embroidered with Z28 and have way better coverage than a factory and most aftermarket mats.
Let me know
Registered User
Joined: Apr 2007
Posts: 38
I am definitely interested. I would like to see how they look in the car with the factory color. The cut is a little different-is it for a couple not convertible right? a pic would be great of the color difference. I looked on the website of theirs and there were 4 different greys and I wasn't sure which this one was.
The mats are for a 99 Z28 and the carpet is darker than the LT1's had. That was more light than my car. I tried to get some from the dealer but they didn't have any. I thought about buying SLP mats but I don't have a SS just so the color would match.
The mats are for a 99 Z28 and the carpet is darker than the LT1's had. That was more light than my car. I tried to get some from the dealer but they didn't have any. I thought about buying SLP mats but I don't have a SS just so the color would match.
Last edited by chevygirl1; Jun 4, 2007 at 12:21 PM.
Registered User
Joined: Apr 2007
Posts: 38
pics to regcarter1@netzero.net on the mats any pics you have now or when you can get some. Thanks.
Thread Starter
Registered User
Joined: Jul 2002
Posts: 1,193
From: San Diego, CA
I am definitely interested. I would like to see how they look in the car with the factory color. The cut is a little different-is it for a couple not convertible right? a pic would be great of the color difference. I looked on the website of theirs and there were 4 different greys and I wasn't sure which this one was.
The mats are for a 99 Z28 and the carpet is darker than the LT1's had. That was more light than my car. I tried to get some from the dealer but they didn't have any. I thought about buying SLP mats but I don't have a SS just so the color would match.
The mats are for a 99 Z28 and the carpet is darker than the LT1's had. That was more light than my car. I tried to get some from the dealer but they didn't have any. I thought about buying SLP mats but I don't have a SS just so the color would match.
As for the cut, they are for a non convertable (if that was even an option). I have a coupe as does my girlfriend. If you do end up buying these mats, I garuntee you will look into upgrading the carpet to match...they are just that nice. Definatley show car quality.
I'll try and send some pictures tonight.
Thread Starter
Registered User
Joined: Jul 2002
Posts: 1,193
From: San Diego, CA
Registered User
Joined: Apr 2007
Posts: 38
My carpet is not the black. They started that in 00. I will check their site out again with the color. If you can just send me some pics of the mats so I can see the all of them and maybe what they look like on the drivers side that would be great. Thanks.