The system was run on my car for about two weeks. It has a small dent in the portion of piping that goes over the rear axle. Since the system was bolted to the car the I-pipe and the pipe connecting to the cat are pretty much fused as one. I took the clamp off but I'm still not able to separate them. You can still install the system but you will need to take down the crossover bars that keep the rear end from moving sideways. Either that or I can cut it in half and you can have it welded back together.

To recap:

Full catback w/ hooker tips , minor scratches, small dent, run on car for two weeks.

Make me an offer.

 

TTT

 

150 shipped to 30518?

 

I'm going to have to cut the I pipe in order to ship it. Otherwise the box is going to be 10 ft. tall. If you're planning to weld the system up then it shouldn't be a problem. If so you've got yourself a deal.

 

Send me pics of the dent, the muffler, and the tips. If it's all decent, you've got a deal.

pouncer7@swirvemail.com

 

PM sent.

 

pm'd ya

 

Spinner, I'll do my best to get some pics to ya today (Tuesday) sometime this afternoon.

Being that I want to be completely honest with you guys there is one more thing I just thought of. When I had everything bolted up and in place the right outlet looked like it was further under the car than the left outlet. It didn't bother me enough to figure out what exactly was going on so I just left it. But if you're concerned about a perfect fit you may need to have a muffler shop do some slight modification to square it up with the car.