I also have a custom chrome moly torque arm that was built by NRC Motorsports. Its a fully adjustable setup, and you will need to weld 2 tabs on each side of the car on the subframe connectors. Nothing hard at all, just a little welding. It also has an adjustable driveshaft loop installed too. It also has been powder coated charcoal, and I have included pictures of that too.

Ive been 1.29 60's consistant all day long with this torque arm in a 3400 lb car.

I would be looking to get $375 for the torque arm setup.

__________________________________________________ __________________________________________________ ____________________

Used 12 bolt Strange/US gear 4.56 gear. Perfect wear pattern and no noise at all. Will sell for $100 OBO

__________________________________________________ __________________________________________________ ____________________



I need this stuff gone ASAP.


** If the buyer decides to use paypal, he/she will pay the 3% charges for using the service, unless other arrangements are made.

I can be reached through the board or through email at smknta95@hotmail.com








Picture of torque arm cross member.

 

Up for the day. This stuff needs to go soon.

 

Up for the day.

 

Up for the morning crew.

 

you can do better on the torque arm ....thats not much less than new....im interested

 

Sent PM.