If anyone is interested I have one of the sweetest LS1 Lid setups on my LT1 car that I am going to sell. I have to start making room for my D1SC setup and I am going to sell the whole kit ready to Bolt on.

MTI LID (best lid from GM high tech) Cost me $110 shipped
K&N Filter Cost me $55 shipped
LS1 bottom portin rad support that holds lid modified for Lt1 with new clips Cost me $35 shipped
2 Fernco 3.5 inch inlet outlet for TB-MAF and MAF-LID Cost me $10 at home Depot.

I also have 2 Foam pieces that block off unwanted hot air these go between the Rad shroud and the mounting spot. Keeps cool charged air into the airbox.

This is going to be a Direct bolt on, I have $210+ in this setup and I will sell it for $140 shipped. I had a SSRA kit for it as well but I have already sold it.
PM me if anyone is interested. I also have a few other small things I will add with the kit, that makes the kit look better. Thanks

I can get pics if needed.

 

Can you send me pics if it isn't any trouble. Thanks. gtpcamaroz@yahoo.com

 

I Think I will just post pics Tomarrow. I will be at work the rest of the day until tonight, and I work till 8-3 tomarrow, so be looking for pics about 5-6. I will just post them on here. Thanks

 

Great, thanks, will keep an eye out.

 

I have been getting a lot of PM's asking if this will fit a Stock LT1 Z28 or T/A hood, The answer is Yes if you do some more aftermarket Work. This setup will Probably not unless you mod it some more. I know it will work on a ultra Z style hood, Warbird hood (Use to have) and of course any LS1 conversion front end. I have ran this kit for over 2 years no Problem. The only reason i am selling is b/c I am going Procharger.
If i was not going Force induction I would Keep this setup.

The only Blemish the kit has is the Top of The MTI Lid where you can see in the pics. It seems to be dented Very Slightly where I had the hood hit it when I first made the setup. I have been running a Sticker Decal so it could not be seen.

The Pics should pretty much explain it all, and if you have any questions either post of PM me.
I am still wanting $140 shipped by Anything but Paypal (got screwed on that). I would like a money Order. The buyer needs to give me about a week to setup my new induction setup Pre-Procharger.

Here are some pics
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]