Up for sale is my Ford 9". This is a moser unit with a full spool, 4:10's, 33 spline axles. It was painted red before I installed it and it has about 5,000 miles on it. I am asking $1500 I would prefer not to ship but if that is what you need you will have to pay the shipping.

I also have a custom 3" aluminum driveshaft that was made 1" longer for the rear end. (stock length will work, but I wanted another 1" so i had a little more tailshaft engagement.) $200 +shipping

Also I have a UMI Performance torque arm with the tunnel brace with the driveshaft loop that is designed for long tubes. $275+ shipping (less than 5,000 miles)

 

Stock length? or is it narrowed?
Stock disc brake mounts? or aftermarket disc brakes?
"N" case? stock? aftermarket?
Spool steel, or alum?

 

It is stock length, and setup with factory brake disc brake mounts. I am not sure about the case so I would say it is stock style. The spool is a steel one.

 

ttt

 

prices dropped

 

Is it set up for ABS? 3 or 4 channel?

 

It is not setup for ABS at all.

 

bump!

 

did this come out of a lt1 fbody?

 

Yes it did.

 

Ttt

 

can you send pic of the UMI Performance torque arm to checkmate1872@aol.com

 

I will snap one tomorrow for you. - Carl

 

Pics sent

 

I also will be including the sphon sway bar brackets(needed to fit factory sway bar on the 9" housing) and the factory sway bar.