This is a complete Delteq setup in "like new" condition. It was mounted on a car, but was not used to my knowledge. This can be used on any LT1 powered vehicle and replaces the "functionality" problems associated with the GM opti. You do NOT have to remove the opti from the vehicle to install this....it is a "plug and play" setup.

Includes:
-Installation instruction manual
-All four (4) wiring harnesses
-Ignition Module blockoff plug
-8 spark plug wires
-Ignition module
-Four (4) ignition coils
-Opti-box/Delteq brain
-Coil pack bracket
-Fasteners

Here is a picture of the setup, but the wires and one connector are not shown in this picture. They DO come with the setup though. This is 100% complete!

$450 shipped

 

to the top!

 

lets say my optical sensor is shot... would i need a new opti in order to run this?

 

Your optical sensors would need to be functioning for the Delteq to work. However, the optics in the LT1 opti are usually NEVER the problem. The sensors are actually quite good in design....I would say that most all opti failures are related the the rotor/cap and no the optics.

Thanks, Jason

 

Here is a picture of the complete kit showing the plug wires.

 

No takers yet.....ttt

 

You have a PM sir...

 

Sold as of 7/3/09

 

Sold to 97Whitez28.

Thanks, Jason