EDIT!! I also have a almost new set of Torq Thrust II wheels and tires for sale. They are 17x9.5 and 17x11 with kumho 712's in the front(275/35/17) and Sumitomo's in the rear(315/35/17) I need to get 1300 out of the setup.

To start off, I am a new member here but have plenty of trader ratings on ebay and ls1tech so no worries! I have a 1997 Camaro Z28 that I will be parting out but the only catch is that the engine and transmission MUST sell before anything else goes! The engine has 107k on it and it runs very strong. The trans has about 20k on a rebuild. The rebuild cost me about 1400. I have moved on to modding my ls1 car and have lost interest in this car. This setup made 279rwh and 311 rwt. I would like to get 3200 out of the complete engine and trans dropout. It also has a newer centerforce dual friction clutch too. The setup is still in the car and can be heard or even test driven. I am located in springfield missouri and local pickup is prefered but I can ship at the buyers expense. If you have any questions you can reach me through pm or call me at 417-593-9230. Thanks, Nathan.




I know these dyno sheets are old but I bought my 2000 Camaro SS shortly after this and barely ever drove the 97.

 

is it wrecked or what? why would you part out a perfect car?

 

The car was wrecked and then repaired but never finished. The body panels never did line up right.

 

To the top!

 

how much for the trans and clutch only?

 

???Make an offer!

 

Will split up!

 

I need the console lid and dash pad. Price shipped to 76040.

 

tranny still for sale?

 

u have both window motors by any chance?

 

i need the drivers side power window switch and door lock switch with bezel

also need shifter boot and plastic ring to go with it and the rubber shifter boot with metal plate under it

 

How about the turn signal stalk - it has cruise control? Shipped to 07647.

 

For all the guys asking for parts, I have not sold the engine or trans yet. I really don't want to sell anything before they sell.

 

I know this is a really old thread but is there any chance you still have the centerforce clutch? If you do about how many miles are on it and much do you want for it?

 

I'm lookin for wiring harness I have a 96 z28 lt1 6 speed