$1400 OBO for complete engine/tranny/harness/PCM ... may part out tranny and engine if you don't want whole setup. Thinking $950 without tranny?

Basic rundown...

- Engine (106K, holds good oil pressure ... over 40psi at idle, 3K on the following):

CC503 cam
CC1.6RRs (self-aligning ... one very slightly damaged on tip)
ISKY Dual Valve Springs/titanium locks/new seats/seals
GMPP timing chain
CC lifters (stock style)
Thunder Pushrods
Over Valve Cover Wires (black)
Vented Opti

- Tranny:

Rebuilt with upgraded bands/clutches and shift kit by Cheasapeke transmissions less than 5 months ago. Shifts like a ****!!!

Slightly tuned for fueling (more room for improvement), ran a 12.69@109 with 3.42's and stock convertor ... a bit more into the tune, stall convertor with 3.73's and you'll be in the low 12's - high 11's!!!

note: Broke a water pump bolt (not drilled out and tapped with any success) but doesn't leak since I used permatex on the gaskets.

May Consider partial trades for aftermarket LS1 stuff ... email me at tburah1@gmail.com (also mention www.camaroz28.com so I know)

Thanks~!

 

I might be interested in the harness if you end up seperating ?
What year ?

 

I might think of parting it out if I don't get any offers soon 'cos I need to get the cash for my LS1 project. It's a '94 harness.

Everybody Else!!!

Pls. Make offers on setup, willing to let go cheap for a decent offer.

 

1.6 rr's... which ones?

 

If you decide to part out... I am interested in the complete intake with fuel rails, etc. shipped to 77328. Watching one on eBay right now, but prefer purchase on here. LMK Dwayne

 

Also, interested in vented opti...

 

these are the self aligning rockers. One of it is damaged on the tip but works fine (although I'd replace it still) ... will update

 

Also, need to mention this ...

Broke one of the bolts (middle one, on pass side) on the water pump, didn't have much success (and I was in a rush to get it done) trying to drill it out so I used permatex on both sides of the gasket and now it holds pretty well.

 

If I don't get a definite sale on the complete system by the end of the week, I'll be parting out soooo ... make your bids on the engine stuff too. Cam maybe spoken for already.

 

Its spoken for tuan if you part it out! Haha, PM me back on efa

 

Ttt !!!

 

responded on EFA

 

Responded back !!! but under Jason's SN

 

Aight ... engine is out ... make offers on all the mods and long block 'cos I'm gonna part it out

 

BIGCOWL-IMP ... still need the harness???

CamaroGuy22 ... still want the Cam right???

Saxmo ... Still interested in intake/fuel rails and opti???

30AnvZ28 ... you interested in the RRs???

Make offers on rest of the setup pls. !!!