Comp Promag 1.6, 7/16 (16)
#1
Comp Promag 1.6, 7/16 (16)
Complete set of comp promag rocker arms. 1.6 ratio, 7/16 stud.
I also have a set of 977 springs with Ti retainers, and a set of Comp HiTech pushrods (stock length). I ran this exact setup on my 306/stock heads setup and went 12.6 @ 114mph.
Rockers for $190 shipped, springs/retainers for $100, and pushrods for $75.
Get a deal: $275 shipped for everything.
Springs/p-rods have about 2000 miles on them.
Ryan
I also have a set of 977 springs with Ti retainers, and a set of Comp HiTech pushrods (stock length). I ran this exact setup on my 306/stock heads setup and went 12.6 @ 114mph.
Rockers for $190 shipped, springs/retainers for $100, and pushrods for $75.
Get a deal: $275 shipped for everything.
Springs/p-rods have about 2000 miles on them.
Ryan
Last edited by 96speed; 01-28-2006 at 10:37 AM.
#2
Re: Comp Promag 1.6, 7/16 (16)
Originally Posted by 96speed
Complete set of comp promag rocker arms. 1.6 ratio, 7/16 stud.
I also have a set of 977 springs with Ti retainers, and a set of Comp HiTech pushrods (stock length). I ran this exact setup on my 306/stock heads setup and went 12.6 @ 114mph.
Rockers for $190 shipped, springs/retainers for $100, and pushrods for $75.
Get a deal: $275 shipped for everything.
Springs/p-rods have about 2000 miles on them.
Ryan
I also have a set of 977 springs with Ti retainers, and a set of Comp HiTech pushrods (stock length). I ran this exact setup on my 306/stock heads setup and went 12.6 @ 114mph.
Rockers for $190 shipped, springs/retainers for $100, and pushrods for $75.
Get a deal: $275 shipped for everything.
Springs/p-rods have about 2000 miles on them.
Ryan
#3
Re: Comp Promag 1.6, 7/16 (16)
I'm going to call dibs on these bad boys(rocker arms only)....
i gots some paypal just beggin to buy a set of rocker arms.
sent u a pm.
can i get a pic of them too?
gundamscythe@hotmail.com
i gots some paypal just beggin to buy a set of rocker arms.
sent u a pm.
can i get a pic of them too?
gundamscythe@hotmail.com
Last edited by blahster; 01-28-2006 at 03:30 PM.
Thread
Thread Starter
Forum
Replies
Last Post