Comp Pro-Magnum 1.6 SA rockers with polylocks for 3/8 stud LT1
Thread Starter
Registered User
Joined: Nov 2000
Posts: 1,937
From: Ft. Worth, TX
Comp Pro-Magnum 1.6 SA rockers with polylocks for 3/8 stud LT1
These were used for a short time before I switched to NSA aluminum rockers on my LT1 TA which I sold thereafter. They are Comp Ulta-Pro-Magnum steel 1.6 Self-Aligning rockers for 3/8" studs with 3/8" Magnum poly locks.
Each Poly lock does have a small mark on the top of them that I intensionally put there in order to easily adjust the lash and know exactly how far I turned the poly lock for pre-load. 2 of the rockers have some very minor marks on the alignment tabs, looks at the pics of them attached. These are the only 2 rockers with any kind of mark on them.
$200 including shipping to the lower 48.
Each Poly lock does have a small mark on the top of them that I intensionally put there in order to easily adjust the lash and know exactly how far I turned the poly lock for pre-load. 2 of the rockers have some very minor marks on the alignment tabs, looks at the pics of them attached. These are the only 2 rockers with any kind of mark on them.
$200 including shipping to the lower 48.
Thread
Thread Starter
Forum
Replies
Last Post
Speeds8erM-1
Drag Racing Technique
6
Jul 18, 2002 11:36 PM