CC306 like new. Has 500 miles on it since it was installed in the new motor. $165 shipped.

Comp stock hardened 7.200 inch push rods. Set of 16. $20 shipped

Set for $175 shipped.

All prices OBO.

The cam is perfectly fine, I'm just going bigger.

 

dibs on pushrods just tell me where to ship the money

 

dibs on cam if it's 112LSA. is it? got pics? got the engraved numbers on the edge of cam?

 

It is on a 112lsa, I can get pics of the engravings tonight if need be.

Paypal is jsetzer@ou.edu or PM me for address.

 

send pics to bbachmann@mail.com of the engravings, i'll verify w/ CC and get back to you tomorrow

 

What springs did you run with this cam and the push rods? i'm interested in the rods but wont know the size i need till i do the geometry. if you still have them

 

I am running a set of the comp c612 springs.

7.2 rods shoud be fine on stock block/heads. They were actually a little bit long on mine, but not enough to hurt anything. Thats with block decked and heads milled.

*Note, these springs may not be for everybody. I think cms only recommends them to .575 lift. Mine have been set up by my engine builder and I will be using the same ones again on my next cam.

 

Cam/pushrods are sold.

Someone beat you guys to it in PMs and got me money first.

Thanks for looking.