|
94'-95' LT1 Arizona Speed and Marine Headers + Y Pipe $250+shipping *pics*
These are 94'-95' LT1 Fbody AS&M headers and Y pipe recently taken off a 94' Trans Am. You can see here that these headers new are almost $800.
http://www.azspeed.com/as19lt1flotu.html All of the EGR and AIR provisions have been plugged, but with some work you may be able to use them. The driver side header is a 2 piece design, it really helps with installation. These headers are NOT warped, they have work great for me over the past year and a half. The headers are used, and have some visual wear. The headers are pretty good, but the Y pipe has surface rust on it. Here is your change to get these cheap. Located in Philadelphia, PA. Please send me a PM or email me at Treview1@hotmail.com Asking $250 + shipping. NO HARDWARE OR GASKETS. http://www.fuelslut.net/ihost/files/343/IMG_0105.jpg http://www.fuelslut.net/ihost/files/343/IMG_0106.JPG http://www.fuelslut.net/ihost/files/343/IMG_0107.JPG http://www.fuelslut.net/ihost/files/343/IMG_0108.JPG http://www.fuelslut.net/ihost/files/343/IMG_0109.JPG http://www.fuelslut.net/ihost/files/343/IMG_0110.JPG http://www.fuelslut.net/ihost/files/343/IMG_0112.JPG http://www.fuelslut.net/ihost/files/343/IMG_0114.JPG |
morning bump....$250 obo!
|
make offer!
|
Where are you located?
|
Did you have any clearance issues with these headers (i.e. between the passenger side collector and k-member, steering shaft and #1 primary tube, etc.)?
|
Originally Posted by onebadponcho
(Post 4918586)
Did you have any clearance issues with these headers (i.e. between the passenger side collector and k-member, steering shaft and #1 primary tube, etc.)?
To answer the above question, I am in Philadelphia, PA. These headers have NO clearance issues at all. I just installed Pacesetter longtubes and found they hit the frame, rub the steering shaft and such. These headers are a straight forward fit, and the engine doesn't need to be jacked up or anything like that. The only tough part is getting the plugs in and out do the design of the primaries. Also, getting to the bolts can be tough but it's not too bad. |
Originally Posted by marzen
(Post 4919120)
To answer the above question, I am in Philadelphia, PA.
These headers have NO clearance issues at all. I just installed Pacesetter longtubes and found they hit the frame, rub the steering shaft and such. These headers are a straight forward fit, and the engine doesn't need to be jacked up or anything like that. The only tough part is getting the plugs in and out do the design of the primaries. Also, getting to the bolts can be tough but it's not too bad. |
$150 shipped to 27215
|
SOLD. Thanks for the interest everybody.
|
| All times are GMT -5. The time now is 09:04 PM. |
© 2024 MH Sub I, LLC dba Internet Brands