Strange Nodular Iron Case
Daytona billet pinion support
4.11 pro gears
Large pinion
3.25" bearings
Full spool
Solid pinion spacer
fully welded housing with back brace installed
1350 billet yoke
35 spline moser axles
rotors, calipers, pads all brand new
caliper mounts ready to be welded where YOU want to put them

The rear is all brand new with exactly ZERO miles on it. I actually bought it for my race car, which has been sold. It is the same width as the stock rear in the nova, only the spring perches need to be moved. I'd have to have $1500 for the rear, as it cost me over $2k and like I said, I never used it. The center section hasn't even been bolted in.

 

Will this work in a 4th gen?

any provisions for ABS?

 

 

I'm guessing its for a nova.. No provision for a torque arm.. And no 9" has a provision for ABS unless its 4 channel....

 

no ABS, and they make torque arm kits that bolt on to the housing. It's the right width for a 4th gen though, but would need your coild pads and control arm mounts welded on.

 

man if i dident just buy a new quad i whould buy this TTT for ya