6 point custom SCCA Stamped/legal roll cage with 3x2 NASCAR door bars, Petty bar, dash bar, pass side X door bar, 1.75" DOM
This is a $2500 cage, pick up in San Jose, CA only
$1200

Moser 9" third gen rearend with 4.11 gears, very new axle seals, auburn pro unit, 12mm wheel studs, torque arm mounts, PBR caliper mounts, Spohn LCA drop brackets welded on.
less then 1000 miles since rebuild
Pick up Santa cruz, CA.
$1200

Ground Control 4 corner adj suspension with front screw type wt jacks and 1000# front springs, 275# rear springs on screw and collars, infinite adjustability.
1 year old, #350 + shipping.

1LE brake setup, calipers, brackets, spindles, rotors, Earl's ss brake line,
Panther race pads, 1 race, great condition
$500

Koni orange single adjustable 1000 miles,
front $250 pair
rear $100 pair

Percy speedglass, rear lexan hatch weighs like 10lbs compared to 50lbs stock glass
new $389, used 2 races $250, with Aluminum straping

Spohn torque arm for Tremec 3550 TKO tranny. $270

Hooker supercomp headers, 1.75' primary, 3" collectors, a bit flat on collector bottom but good condition:
$200

Griffin HD radiator, extra thick Aluminum model, $400 new, 2 months old, $200

assorted GTA mesh and IrocZ, enkie gta style, 16x8 rims, fair appearance, (painted NASCAR black, good physical condition, 8 front, 4 rear offsets,

6 BFG R1 255/55/16 with various life left

383 4 bolt, short block, 400hp/415 torque, new crank $500 disassembled
pan, valve covers, clutch, flywheel, water pump, alt, ps pump all brackets available

World SR Torquer heads, ported and polished, 2.02, NICE! $500

Fiberglass Iroc hood with cowl hood scoop rivited on (or off) 2.5 inch or 4 inch
various front fenders, doors, gutted or semi gutted, new front bumper with grill and lower air dam, '91 style

Aluminum drive shaft, possibly available

Also available front control arms with
metal bushings installed

email: dregsz@yahoo.com

 

You have mail. Thanks.

Eric

 

The whole car, less motor and tranny is available as a roller for $3k, there is some damage to the r rear 1/4 panel

 

You've got mail.

-Jesse

 

how much for the complete engine with all brakets

 

still have the hooker 2210 long tubes?

are there any gouges in them or just bent colector? do they still make seal?

thanks
anthony

 

There are a couple of places where I beat on them to make them clear a fitting or the starter, but no gouges

 

I am interested in the front bumper with chin spoiler (GFX). I sent you an email, but I guess you didn't get it.

can you send me an email with the details on it and a price. I'd also need that shipped to Colorado Springs, 80917 if you are willing to do that.

j_hougnon@hotmail.com

Thanks,
Jesse