SprayedZ28

Im selling the LT1 out of my Z28. Pulled it out to get the car ready for the new motor. 90K miles.

Longblock oil pan to intake,

Ill throw in the fuel rail and injectors as well.

Made around 30psi of oil pressure at idle when warm.

No smoke whatsoever, leaked no oil. Plenty of RTV to ensure that

CC305 Camshaft, heads are home ported not pretty but they work, ARP headbolts and Impy headgaskets(raise compression)
Motor made right at 360 rwhp with full exhaust, cold air, and 1.6 rockers.

In the drivers side picture you can see half the side of the motor is black due to an exhaust leak. I put stock manifolds on the car a while back because I was going to sell it, but apparently it had an exhaust leak at the collector on the drivers side. You could just barely hear it. I havent cleaned the motor up since I pulled it 2 months ago. Still has oil in it.

$1000. OBO Plus shipping. Located in North Florida. PM if interested, havent had that email account for some time now.

www.jaxracing.com/riceklr/LT1front.JPG
www.jaxracing.com/riceklr/LT1driver.JPG
www.jaxracing.com/riceklr/LT1passenger.JPG

SprayedZ28

Bump

SprayedZ28

Bump

SprayedZ28

Ttt

Acct 23749

$600 will pick up

SprayedZ28

Id go 800 and deliver

Ill keep it for 600, nothing wrong with it.

SprayedZ28

Ok, now Im kinda in a bind for money, so make some offers.

seawolf06

$800 delivered?

seawolf06

What all did you replace when doing the cam/RR? Did you upgrade the timing chain, lifters, pushrods, springs? What kind of RR? What year was this(i.e. vented/non-vented camshaft?)

SprayedZ28

Its a non vented 93 motor. It had a new cam, new lifters and timing chain. The swap was done about 3 years ago, not sure how many miles since the swap but I drove it pretty much daily for 2 years.

Your in LA, Ill go 750 and meet you in Mobile, AL.