3" Steel Driveshaft
Thread Starter
Registered User
Joined: Nov 2000
Posts: 157
From: Columbus,Ohio
3" Steel Driveshaft
I have a 3" steel driveshaft made from .083 tubing that was used to connect a 700R4 transmission to a Moser Ford 9" rearend in a 3rd gen camaro. It includes a Spicer yoke (27 spline) and U-joints. The U-joint diameter is 1-1/8”. The width is 3 5/8”.
This part was made for the car and not used for very long so it is in great condition. The length from the rearend u-joint midpoint to the seal on the tailshaft is roughly 48.5 inches. U-joint to U-joint midpoint is roughly 45.5". Item is located in the central Ohio area 43068. Pictures available.
This part was made for the car and not used for very long so it is in great condition. The length from the rearend u-joint midpoint to the seal on the tailshaft is roughly 48.5 inches. U-joint to U-joint midpoint is roughly 45.5". Item is located in the central Ohio area 43068. Pictures available.
Thread Starter
Registered User
Joined: Nov 2000
Posts: 157
From: Columbus,Ohio
I have put together a photo album of parts I am selling. Here is the link for the driveshaft:
http://s564.photobucket.com/albums/s...view=slideshow
http://s564.photobucket.com/albums/s...view=slideshow
Thread
Thread Starter
Forum
Replies
Last Post