1994 F-Body stuff for sale (opti, TB, DS, etc.)
02-14-2005, 02:17 PM
#1
Registered User
Thread Starter
Join Date: Feb 2001
Location: Charleston, WV, U.S.
Posts: 1,084
1994 F-Body stuff for sale (opti, TB, DS, etc.)
All from my 94 Z in sig:
Used opti (non vented) w/44K miles. $70.00 shipped Works fine as far as I know, replaced it with a new vented opti during rebuild. I had a "once in awhile miss" at high rpm's before the rebuild ...but I'm betting it was the plug wires after looking at them. Make offer.
Used stock 48mm throttle body ...good condition. Make offer. SOLD
Used stock driveshaft w/35K miles. Balanced and undercoated. I thought it was the source of my noise but even after installing a new Denny's driveshaft I still have the same noise. Since it balanced ok I would say it's a noise free stock shaft. Make offer
Used posi ...not the greatest, mostly right wheel drive but it's still better than an open differential. Make offer.
Stock cam with 44K miles, excellent condition ...make offer.
Stock lifters w/44K ...good condition, make offer.
Stock timing set and cover, good condition ...make offer.
I also have a "Jegster" universal driveshaft loop that has never been used that has a half-*** paint job.
Have all but two factory hardened pushrods (two were bent) that are in good condition.
Last and certainly not least ....I am considering sellling the car. "In a nutshell" what you would get is an excellent condition Polo-metallic Green II Supercharged Z28 Coupe with 44K miles, Powerdyne BD-11 w/mods and bypass valve w/6.5K miles w/42# injectors (SVO) and FMU eliminated, M6, new LT4 clutch/SLP flywheel combo, new forged 355 w/studded mains, new Lloyd Elliot heads (265/195) w/port matched intake, new BBK 58mm TB, "new" Eaton take-off posi, barely used GM 3.73's, Hooker LT's w/Paul Barry coating, Mufflex Y-Pipe w/Barry coating, Borla Catback w/DMH E-Valve, full instrumentation including Scanmaster in middle A/C vent, LT1 Edit w/molded AKA cable, Eibach Pro Kit, boxed LCA's, boxed SFC's, LCA relo brackets, Pro 5.0 shifter, wood kit in interior, white faced gauges, leather interior (tan), Summit rearend support cover, Denny's heavy duty driveshaft, 12 disc cd changer, factory 16 x 8 1997 Trans Am wheels, barely used Eagle GS-D3 245/50 tires up front, Nitto DR's (245/50) on the rear w/6.5K. RK Sport Billet grille, paint matched/masked turnsignal, corner, and taillight covers, clear headlight covers, front end recently repainted/repaired from dog accident ...buckets are painted with the rest of the nose, looks much better than stock ...very good quality paint job. Brakes recently replaced. There is more but those are the important things. This engine was built to handle 9 PSI (9.5:1 c.r.) to produce approx 500-525 rwhp. Right now at 6 PSI even w/the little Powerdyne it should make roughly 450 rwhp since these heads flow really well and have a custom matched cam (Reed 220/226/112+6/.544 I&E). $13,500 obo
Used opti (non vented) w/44K miles. $70.00 shipped Works fine as far as I know, replaced it with a new vented opti during rebuild. I had a "once in awhile miss" at high rpm's before the rebuild ...but I'm betting it was the plug wires after looking at them. Make offer.
Used stock 48mm throttle body ...good condition. Make offer. SOLD
Used stock driveshaft w/35K miles. Balanced and undercoated. I thought it was the source of my noise but even after installing a new Denny's driveshaft I still have the same noise. Since it balanced ok I would say it's a noise free stock shaft. Make offer
Used posi ...not the greatest, mostly right wheel drive but it's still better than an open differential. Make offer.
Stock cam with 44K miles, excellent condition ...make offer.
Stock lifters w/44K ...good condition, make offer.
Stock timing set and cover, good condition ...make offer.
I also have a "Jegster" universal driveshaft loop that has never been used that has a half-*** paint job.
Have all but two factory hardened pushrods (two were bent) that are in good condition.
Last and certainly not least ....I am considering sellling the car. "In a nutshell" what you would get is an excellent condition Polo-metallic Green II Supercharged Z28 Coupe with 44K miles, Powerdyne BD-11 w/mods and bypass valve w/6.5K miles w/42# injectors (SVO) and FMU eliminated, M6, new LT4 clutch/SLP flywheel combo, new forged 355 w/studded mains, new Lloyd Elliot heads (265/195) w/port matched intake, new BBK 58mm TB, "new" Eaton take-off posi, barely used GM 3.73's, Hooker LT's w/Paul Barry coating, Mufflex Y-Pipe w/Barry coating, Borla Catback w/DMH E-Valve, full instrumentation including Scanmaster in middle A/C vent, LT1 Edit w/molded AKA cable, Eibach Pro Kit, boxed LCA's, boxed SFC's, LCA relo brackets, Pro 5.0 shifter, wood kit in interior, white faced gauges, leather interior (tan), Summit rearend support cover, Denny's heavy duty driveshaft, 12 disc cd changer, factory 16 x 8 1997 Trans Am wheels, barely used Eagle GS-D3 245/50 tires up front, Nitto DR's (245/50) on the rear w/6.5K. RK Sport Billet grille, paint matched/masked turnsignal, corner, and taillight covers, clear headlight covers, front end recently repainted/repaired from dog accident ...buckets are painted with the rest of the nose, looks much better than stock ...very good quality paint job. Brakes recently replaced. There is more but those are the important things. This engine was built to handle 9 PSI (9.5:1 c.r.) to produce approx 500-525 rwhp. Right now at 6 PSI even w/the little Powerdyne it should make roughly 450 rwhp since these heads flow really well and have a custom matched cam (Reed 220/226/112+6/.544 I&E). $13,500 obo
Last edited by canbaufo; 03-02-2005 at 08:57 AM.
02-15-2005, 09:44 AM
#3
Registered User
Thread Starter
Join Date: Feb 2001
Location: Charleston, WV, U.S.
Posts: 1,084
Re: 1994 F-Body stuff for sale (opti, TB, DS, etc.)
BTW, please e-mail or post here rather than PM'ing me ....I have a miserably slow internet connection. Thanks
Last edited by canbaufo; 02-15-2005 at 12:48 PM.
02-18-2005, 11:44 AM
#5
Registered User
Thread Starter
Join Date: Feb 2001
Location: Charleston, WV, U.S.
Posts: 1,084
Re: 1994 F-Body stuff for sale (opti, TB, DS, etc.)
Originally Posted by 89305rs
$20 shipped for the stock 48mm TB?
02-20-2005, 09:37 PM
#8
Registered User
Thread Starter
Join Date: Feb 2001
Location: Charleston, WV, U.S.
Posts: 1,084
Re: 1994 F-Body stuff for sale (opti, TB, DS, etc.)
Originally Posted by Jakeav11
how much for the opti shipped?
02-21-2005, 10:26 PM
#11
Registered User
Thread Starter
Join Date: Feb 2001
Location: Charleston, WV, U.S.
Posts: 1,084
Re: 1994 F-Body stuff for sale (opti, TB, DS, etc.)
Originally Posted by biohaz84
Interested in driveshaft, is it alum.? It will bolt to a 3rd gen right?
The wheels and tires are not for sale, the whole car is for sale and won't be parted out. Only the old left over stock stuff is for sale.
02-28-2005, 08:28 PM
#12
Registered User
Thread Starter
Join Date: Feb 2001
Location: Charleston, WV, U.S.
Posts: 1,084
Re: 1994 F-Body stuff for sale (opti, TB, DS, etc.)
Throttle body is the only thing I've sold
I would like $70.00 shipped for the opti ...pretty reasonable.
Still accepting offers on the rest
Edit: BTW I totally forgot! ...I still have the stock clutch, PP, and flywheel in good condition with 44K miles. There are minor hot spots but there is plenty of use left in all three items ....they were not raced on but maybe 12 times in the 1/8 mile and weren't abused on the street. Make offer.
I would like $70.00 shipped for the opti ...pretty reasonable.
Still accepting offers on the rest
Edit: BTW I totally forgot! ...I still have the stock clutch, PP, and flywheel in good condition with 44K miles. There are minor hot spots but there is plenty of use left in all three items ....they were not raced on but maybe 12 times in the 1/8 mile and weren't abused on the street. Make offer.
Last edited by canbaufo; 02-28-2005 at 08:31 PM.
03-01-2005, 10:32 PM
#15
Registered User
Thread Starter
Join Date: Feb 2001
Location: Charleston, WV, U.S.
Posts: 1,084
Re: 1994 F-Body stuff for sale (opti, TB, DS, etc.)
Originally Posted by serpentbmf
how much for the lifters?? very interested
The opti and the rest is still for sale, except for the throttle body. $70 shipped for the opti and accepting all reasonable offers on the rest!