As Stated. Electric Pump is New. Housing has had the barbs removed and tapped for NPT fittings (Done after picture was taken).

http://www.outlawrace.com/Z28/23.jpg

$175 + Ship

Kurtis

 

Sold Kurtis. I'll take it.

:-)

 

Although I just need to check that it will not foul my crank pulley and tensioner pulley. Oh. I guess I better find out what NPT fittngs are as well LOL.

 

I don't see why it would effect your pulley system.....

I was planning on using braided hose w/ AN Fittings for the smaller lines coming off the pump. You could do the same, or you could just use NPT to Barb Adapters. and pretty much use what ya got......

http://holley.com/HiOctn/ProdLine/Pr.../982203ERL.jpg

or

http://holley.com/HiOctn/ProdLine/Pr.../984204ERL.jpg

Obviously these fittings can be done in stright or angled as pictured, just depenbds on the hose is routed.

Let me know ASAP Shaun.

 

I posted a question in the FI section but all being well I'll get money to you today via email.

What email address you want me to send the money too? I have done this before. My bank allows me to email money to peeps. They get an email with the details and then I think they enter the account where they want it deposited too.

 

KTamez1320@hotmail.com works for me. Figure $12 to ship it Shaun.

Thanx!

 

For $12 its worth it to ship...Yakima is a LONG drive, trust me

Andy

 

I will second that, just when you think you are there.........you see another long strip of rolling hills.......

 

OK I'm firm on the deal Kurtis. However, it LOOKS like I can only email $CDN. I'll check with the bank and either email $USD to you or get a bank draft sent.

 

OK, no problem Shaun, just let me know. I'll consider it sold.