just wanted to introdducee myselff...dane1969...i just bought my 1995 z28 last thursday..jan.19.2012...here is a list of what has been done to the car...


MOTOR: 350ci Cast iron Block Bored .30 over to 355ci
LT4 Hot Cam Kit Duration .050in. 218/228, lift .525/.525
1.6 Roller Rockers, Hardened Springs, 1 piece hardened push rods, and
Forged Pistons and Rods.
Ported and Polished Heads and Intake with 58mm Throttle Body
LT4 Knock Sensors, 160 Degree Thermostat, and MSD Distributor
SPECTRE Twin 6in.Cones for the Cold Air Intake with Mass airflow sensor
36 Pound Fuel Injectors with Aeromotive Fuel Pressure Regulator(30-70psi)
and Gauge. 255Lph Granatelli In tank fuel pump.
Pacesetter Long tube Headers out to a 3in. Emissions Removed (No Catts)
into a 3in. Mandrel bent X-pipe Dumped before rear Axel with Moroso
Spiral Flow Race Mufflers.

Transmission: T-56 6-Speed With Hurst Short Through Shifter with
T-Handle or Hurst Ball, and Polyurethane trans mount.

Rear Differential: 10 Bolt with Posi 3.42 Gears and 28 Splines

Extras: Nitto 555 Radials on all 4 rims, 11.5in. rims in rear
with size 315/35/17 Tires and 10.5in. Front Rims with size
245/45/17 Tires 97.9% Tread on all 4 Rims.
-Excalibur Remote start 2 way system with 2 remotes
-Euro Lamp Brand Front Driving Lights (Fits almost any size Bulb)
-Full Rebuilt Ac Unit Cold AC when neeeded and warm heater when neeeded

what do u think this car should run in the 1/4??...i i got 4.10's and moser axels on order should get them tuesday or wensday should wake up the m6 nicely i hope!!!

 

Welcome to the board. Sounds like a lot of work has been done to the car. No idea about performance, especially with a six speed.

 

Welcome!

 

Post up some pic's & welcome!

 

welcome, get some pics up!

have any sticky tires to put that power down? with a good drag radial i think high 11s could happen.