either will work.....

but this is how I would do it...

 

i have 05 gto 6 spd and a zex 82026 with bottle warmer and dual purge with red leds and have everything hooked up but the bmn window switch and the relay and the fpss so if i had a diagram for that it would be so cool.
P.S. I bought the bmn/fpss from nitro daves so it's kinda like customer support--thanks in advance

 

BMN window switch with ZEX controller

B will connect to the red wire on the ZEX box
FPSS will go inline on the purple wire from the BMN going to 86 on the relay

 

u da man

 

Can you show a normally open switch added in after the WOT switch so that you can get out of the kit without getting out of the throttle or disarming the kit? This way you could just let off the kit if you lost traction, but without getting out of the throttle.


So that you have arming switch------->WOT switch-------->Normally open push/hold button------->Relay------->Solenoids.


I would assume that you wouldn't have to worry about a ground on the push button switch but I am unsure about this since I have never wired a kit up like this. Just something that I want to try out on my setup.


Thanks,
Eddie

 

it would be a 2 wire switch that wires the same as the WOT in the diagram....just duplicate the push button inline on the wire inbetween the ACC pin on the arm switch and pin 86 on the relay

 

Okay, cool, that's what I thought.


Thanks

 

I need one for :

Nos Single stage big shot plate

FPSS

microswitch activation on button

Accel 300+ with the 375+ retard box(12 volt retard activation)

Stand alone fuel system.

Purge

Activated from a Nitrous outlet ash tray switch panel

BTW dont you guys have a special going on the switch panel?
Part number NO-00-11011

Thanks guys

 

3rd diagram in the 1st post

 

Hey Ray, how about one with the FJO in it. Thanks.

 

2nd picture in post #2

 

can i get a diagram using the malory 685, im using the 2 step and window switch and need to run the step through a relay so i dont spray on 2 step haha...that would = goodbye 4th 1LE elbow

 

I'm trying to figure out how to install the Zex tration control window switch on my 2000 Camaro Z28.
I am using WOT switch to cut the nitrous on at the present time.
What I need to know is where does the green tach wire go?

 

NX Wet kit with FPSS and BNM WS.

 

Please help! I sent you a email Ray, no response? I have a 94 Z with a 6al a efi wet kit with your switch panel and all the accys (purge,warmer) I have a jacobs mastermind and want to hook it up right the first time, any diagram for that setup Thank You