ShownomercyZ28

I am trying to install my Nitrous outlet plate for my LT1. I have a 58mm BBK and the IAC seems to be hitting the thermo housing and I can't get the holes to align with the plate in.

Any ideas?

Ray@NitroDaves

you need to clearance the thermostat housing and IAC....take material off in small increment while marking where it is hitting...give us a call if you need better instructions

ShownomercyZ28

Yea, I called you earlier to confirm my suspicions.

Another random install question, I bought the kit used and it did not come with the extensions for the throttle cable plate. Can I get the from you separate?

Ray@NitroDaves

yes

ugggh...This forum requires that you wait 60 seconds between posts. Please try again in 35 seconds.

ShownomercyZ28

LOL, any idea on how much they would run me?

Ray@NitroDaves

$25...will need to call order in

ShownomercyZ28

Got the plate on today after some grinding and I hooked up the throttle figuring it would be way off but it was spot on.... Had some one look while I hit the gas pedal and blades opened WOT perfectly flat and closed like they should at idle.... weird?

jqueen612

Jegs sells 1/8" water pump spacers that will move the pump and housing out enough to let the nitrous plate clear everything